User manual AEG-ELECTROLUX ESF6210LJW

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] Your local Water Authority can advise you on the hardness of the water in your area. The water softener must be set in both ways: manually, using the water hardness dial and electronically, using the function buttons on the control panel. a) Setting manually 1. The dishwasher is factory set at position 2. AA07 Water hardness °dH 51 - 70 43 - 50 37 - 42 29 - 36 23 - 28 19 - 22 15 - 18 11 - 14 4 - 10 <4 °TH 91 - 125 76 - 90 65 - 75 51 - 64 40 - 50 33 - 39 26 - 32 19 - 25 7 - 18 <7 mmol/l 9, 0 - 12, 5 7, 6 - 8, 9 6, 5 - 7, 5 5, 1 - 6, 4 4, 0 - 5, 0 3, 9 - 3, 3 2, 6 - 3, 2 1, 9 - 2, 5 0, 7 - 1, 8 < 0, 7 Range IV IV IV IV IV III III II I/II I Adjusting the water hardness setting manually 2 2 2 2 2 2 1 1 1 1 electronically level 10 level 9 level 8 level 7 level 6 level 5 level 4 level 3 level 2 level 1 Level indicated in the digital display Use of salt yes yes yes yes yes yes yes yes yes no 8 Filling with dishwasher salt Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion. Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Filling with rinse aid 1. The maximum level for filling is indicated by "max". To fill: 1. Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel provided, pour in the salt until the container is full. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. For best results we recommend you to use the cutlery grid provided (if the size and dimensions of the cutlery allow it). The cutlery basket can be placed either to the left or to the right of the lower basket. The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) must be loaded in the US47 upper basket and arranged so they do not move. US73 UI42 For glasses with long stems (according to the size and dimensions), upset the glass holder to the left-hand or right-hand position. In case you need to load dishes in the upper basket, the glass holder must be in the right-hand position. In case that plates are loaded in the upper basket: load them starting from the rear positions of the basket; tilting them slightly forwards and avoiding the front positions near the door. US71 Before closing the door, ensure that the spray arms can rotate freely. 11 Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm Fill with detergent To move to the higher position proceed as follows: 1. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent Attention! Never lift or lower the basket on one side only When the basket is in the higher position you will not be able to use the cup rack(s). RC08 DE19 DE22 To lower the basket to the original position proceed as follows: 1. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it. [. . . ] - continous flashing of the indicator light of the running programme - in the digital display appears Possible cause The water tap is blocked or furred with limescale. The filter (where present) in the threaded hose fitting at the water inlet valve is blocked. The water inlet hose has not been correctly laid or it is bent or squashed. The water drain hose has not been correctly laid or it is bent or squashed. Solutions Clean the water tap. [. . . ]