User manual AEG-ELECTROLUX ESF6560ROW

[. . . ] Children should not be allowed to tamper with the controls or play with the product. Keep all detergents in a safe place out of children's reach. Materials marked with the symbol recyclable. are q q q Check with your local Council or Environmental Health Office to see if there are facilities in your area for re-cycling this appliance. When the appliance is to be scrapped, cut off the power supply cable and make the door closing device unusable to prevent young children from being trapped inside. Help to keep your country tidy - use authorised disposal sites for your old appliance. q During Use q Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals must not be washed in this dishwasher. [. . . ] Ensure that the electrical and water connections comply with the installation instructions 2. Pour 1 litre of water inside the salt container and then fill with salt 4. Run a Rinse and Hold programme. Filling with salt (specifically designed for use in dishwashers) The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the appliance. If your water is already soft (lower than 8°TH or 4°dH) there is no need to use salt. Your local Water Authority can advise you on the hardness of the water in your area. 1 2 3 4 5 SR15 SR20 SR19 4 152978 39/1 14-06-2001 8:51 Pagina 5 Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion. The salt container will require topping up periodically ( every 40 cycles). Do not worry if water over flows from the unit when filling with salt, this is quite normal. Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Filling with rinse aid 1. Top up the rinse aid when the indicator (B) becomes clear. BR01 B m a x 6543 21 A BR03 Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Crockery and cutlery A On/Off 25 g 5g Cold prewash Main wash up to 65°C 2 cold rinses 1 hot rinse Drying Main wash up to 65°C 2 cold rinses 1 hot rinse Drying Normal 65°C without prewash Light soil. Crockery and cutlery B On/Off 30 g / Rinse and Hold Any. Partial load (to be completed later in the day). C On/Off / / 1 cold rinse, (to avoid food scraps from sticking together). 7 152978 39/1 14-06-2001 8:51 Pagina 8 Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. Cleaning the central filter (After each wash) Scraps of food may accumulate in the drain filter (A) and should be removed by rinsing the filter under running water. Once cleaned, refit the filter by pushing it back to its original position until it engages. A MA04 MA19 Cleaning the large filter (Every week) 90° B C MA20 MA21 MA18 MA05 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. [. . . ] When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. IN05 570 - 600 600 Water supply connections This dishwasher must be plumbed into a cold water supply. The water pressure must be within the limits given in the technical specifications. Your local Water Authority will advise you on the average mains pressure in your area. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. [. . . ]