User manual AEG-ELECTROLUX ESF67020

[. . . ] Good luck! 4 electrolux contents Contents Safety information Product description Control panel First use Daily use Washing programmes Care and cleaning Something not working Technical data Hints for test institutes Installation Environment concerns Guarantee/Customer Service 5 7 8 11 15 28 30 32 35 37 38 42 43 The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information safety information electrolux 5 Safety information q In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Once the programme is running, the "3 in 1 function" can NO longer be changed. If you want to exclude the "3 in 1 function" you have to cancel the programme setting and then deactivate the "3 in 1 function". In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the 3 in 1 function Press simultaneously the two buttons positioned over the writing 3 in 1, until the "3 in 1 function "indicator light illuminates. This means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the "3 in 1" symbol turns off. If the drying results are not satisfactory we suggest that you: 1. Set the rinse aid dosage to position 2. q The activation/deactivation of the rinse aid dispenser can only be possible with the "3 in 1 function" active. 24 electrolux daily use Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons 2 and 3, until the lights of buttons 1, 2, and 3 start flashing. If you decide to turn back to the use of standard detergent system we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Press button 2, the lights of buttons 1 and 3 turn off while the light of button 2 goes on flashing. To change the setting, press button 2 again, the digital display indicates the new setting. This programme does not require the use of detergent. Heavy soil Intensive Crockery, cutlery, pots and pans Normal soil Auto Crockery, cutlery, pots and pans Light soil Quick Crockery and cutlery Normal soil Eco Crockery and cutlery Rinse Any. Partial load (to be completed later in the day). washing programmes electrolux 29 Washing programmes information "Auto" washing programme During the "Auto" washing programme the amount of soil on the dishes is determined by how cloudy the water is. If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. For this reason the programme duration, water and energy consumption levels can vary within the stated range for "Auto" programme (see "Washing programmes chart"). During the "Auto" programme the temperature of the main wash water is also automatically adjusted between 50C and 65C depending on the amount of soil on the dishes. 30 electrolux care and cleaning Care and cleaning Cleaning the filters The filters must be checked and cleaned from time to time. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). Remove the flat filter from the Before cleaning the filters ensure that the machine is switched off. The dishwasher filter system comprises a coarse filter (A), a microfilter (B) and a flat filter. Unlock the filter system using the handle on the microfilter, and remove. base of the washing compartment and clean both faces thoroughly. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly. [. . . ] The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. We therefore advise you to remove it. installation electrolux 41 Electrical connection Safety standards require the appliance to be earthed. [. . . ]