User manual AEG-ELECTROLUX ESF67020X

[. . . ] Good luck! 4 electrolux contents Contents Safety information Product description Control panel First use Daily use Washing programmes Care and cleaning Something not working Technical data Hints for test institutes Installation Environment concerns Guarantee/Customer Service 5 7 8 11 15 28 30 32 35 37 38 43 44 The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information safety information electrolux 5 Safety information q In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the 3 in 1 function Press simultaneously the two buttons positioned over the writing 3 in 1, until the "3 in 1 function "indicator light illuminates. This means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the "3 in 1" symbol turns off. If the drying results are not satisfactory we suggest that you: 1. Set the rinse aid dosage to position 2. q The activation/deactivation of the rinse aid dispenser can only be possible with the "3 in 1 function" active. 24 electrolux daily use Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons 2 and 3, until the lights of buttons 1, 2, and 3 start flashing. If you decide to turn back to the use of standard detergent system we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Press button 2, the lights of buttons 1 and 3 turn off while the light of button 2 goes on flashing. To change the setting, press button 2 again, the digital display indicates the new setting. To memorise the operation, switch off the dishwasher by pressing the On/Off button. daily use electrolux 25 Select and start a washing programme 2. The number in the display is no longer flashing but fixed with static light. If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. For this reason the programme duration, water and energy consumption levels can vary within the stated range for "Auto" programme (see "Washing programmes chart"). During the "Auto" programme the temperature of the main wash water is also automatically adjusted between 50C and 65C depending on the amount of soil on the dishes. 30 electrolux care and cleaning Care and cleaning Cleaning the filters The filters must be checked and cleaned from time to time. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. Before cleaning the filters ensure that the machine is switched off. The dishwasher filter system comprises a coarse filter (A), a microfilter (B) and a flat filter. Unlock the filter system using the handle on the microfilter, and remove. 7. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly. Place the coarse filter (A) in the microfilter (B) and press together. Put the filter combination in place and lock by turning the handle clockwise to the stop. [. . . ] The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. [. . . ]