User manual AEG-ELECTROLUX F50860U

[. . . ] ⷠDo not put flammable products or items that are wet with flammable products in, near or on the appliance. Put the knives and all items with sharp points in the cutlery basket with their points down. If not, put in a horizontal position in the upper basket or in the knife basket. Types of salt that are not specified for dishwashers can cause damage to the water softener. [. . . ] ⷠThe first time you use the appliance, make sure that the hoses do not have water leaks. The water inlet hose has a safety valve and a double sheath with an inner mains cable. If there is a leak in the water inlet hose, the safety valve interrupts the flow of water. ­ Be careful when you connect the water inlet hose: ­ Do not put the water inlet hose or the safety valve in water. ­ If the water inlet hose or the safety valve are damaged, immediately disconnect the mains plug from the mains socket. Make sure that the electrical information on the rating plate agrees with the power supply. Make sure not to squash or cause damage to the mains plug and cable behind the appliance. ⷠMake sure that there is access to the mains plug after the installation. To prevent the risk of injury or damage: ­ Disconnect the mains plug from the mains socket. ⷠIf an accident occurs with these detergents, contact immediately a physician. ⷠIf the detergent gets into the mouth, contact immediately a physician. It is correct that water comes out from the salt container when you fill it with salt. To help the environment, do not use more than the correct quantity of detergent. If the washing programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . These cannot fully dissolve with short washing programmes and can decrease the washing results. Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. Multitab function You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Be sure that these tablets are applicable for the water hardness in your area (refer to the instructions on the packaging of the products). activate or deactivate the multitab function before the start of a washing programme. [. . . ] Press the delay button again and again until the display shows the time of the washing programme. Press the delay button again and again until the display shows the time of the washing programme. If the washing programme has not started, you can change the selection. To change the selection while the washing programme operates, it is necessary to cancel the programme. [. . . ]