User manual AEG-ELECTROLUX FAV40830W

[. . . ] FAVORIT 40830 Dishwasher User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Useful tips and hints Environmental information 2 Contents Operating Instructions. 43 3 Operating Instructions 1 Safety Prior to using for the first time · Follow the "Instructions for installation and connection". Correct use · The dishwasher is only intended for washing domestic dishes. [. . . ] Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. Cleaning the spray arm jets Regularly check the jets in the spray arms for blockages. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 26 What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: ­ Fault codeÅ 10 (Problems with water inlet), ­ Fault codeÅ 20 (Problems with water drainage), please have a look at the following table. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. Malfunction Possible cause Water tap is blocked with limescale or faulty. The cycle indicator for the selected dishwashing cycle is flashing: fault code Å 10 is displayed in the multi-display: (Problems with water inlet) Remedy Check the water tap and have it repaired if necessary. Turn the tap on. The filter (where present) in Clean the filter in the the threaded hose fitting threaded hose fitting. Cancel the dishwashing cycle (see chapter: Starting a dishwashing cycle), clean filters (see chapter: Cleaning the filters), then start the dishwashing cycle again. Filters in the base of the dishwasher compartment are blocked. Water inlet hose Check the position of the has not been correctly posihose. The cycle indicator for the selected dishwashing cycle is flashing, fault code Å 20 is displayed in the multi-display. Clean out sink outlet. Water drain hose Check the position of the has not been correctly posihose. tioned. 27 Malfunction Fault code Å 30 is displayed in the multi-display. Possible cause The anti-flood system has been triggered. The mains plug is not plugged in. Remedy First shut off the water tap, then switch off the appliance and contact the Customer Care Department. Plug in mains plug. The cycle is not starting. A fuse in the house's wiring Replace fuse. For dishwasher models with If the dishes are to be a delay start timer: washed immediately, cancel A start time has been sethe delay start. lected. The dishwashing compartment is made from rustfree stainless steel. Rust spots in the dishwashing compartment are due to Rust spots are visible in Only wash cutlery, dishes rust particles from external the dishwashing compartand pans that are suitable sources (rust particles from ment. Remove such spots with a commercially-available stainless steel cleaning product. Decalcify appliance with commercially available agents for cleaning dishA whistling noise can be washers. The whistling is not a cause heard when washing dishIf the noises can still be for concern. [. . . ] Nor will the guarantee cover those caused by inadequate installation or assembly, lack of maintenance or failure to respect the assembly instructions or directions for use. Defects that result from repairs or measures carried out by people who are not qualified or expert or defects that result from the addition of non-original accessories or spare parts are not covered by the guarantee. Appliances that are easy to transport may be delivered or sent to the consumer services department. Home repairs are only anticipated for bulky appliances or built-in appliances. [. . . ]