User manual AEG-ELECTROLUX FAV50879

[. . . ] FAVORIT 50879 U Dishwasher User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Useful tips and hints Environmental information 2 Contents Operating Instructions. 43 3 Operating Instructions 1 Safety Prior to using for the first time · Follow the "Instructions for installation and connection". Correct use · The dishwasher is only intended for washing domestic dishes. [. . . ] During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to the size of the load, degree of soiling, etc. 3 Interrupting or aborting a dishwashing cycle Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. The LED indicators of all the programme buttons that can be selected light up. If you want to start a new cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 23 Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi-display. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Switching off the dishwasher Do not switch off the dishwasher until the multi-display indicates "0" for the remaining cycle time. Therefore leave the dishes to cool for about 15 minutes before removing them. · Dishes dry more quickly if you open the door for a moment after the cycle has ended and then leave it slightly open. 1 3 Removing the dishes It is normal for the inner door and the dispensers to be damp. This way you avoid dripping water from the upper basket onto dishes in the lower basket. 24 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth and clean warm water. · Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters 3 The filters must be regularly checked and cleaned. Turn the handle about ¼ of a turn anticlockwise (A) and remove the filter system (B). 3. Grasp the grip hole on the fine filter (1) and remove it from the micro-filter (2). Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. Cleaning the spray arm jets Regularly check the jets in the spray arms for blockages. [. . . ] Important: ­ The plug must be accessible after the appliance has been installed. ­ Following installation, live parts and insulated wiring must not be accessible to a test finger in accordance with DIN EN 60335-1. Connecting systems The water inlet hose, drain hose and the mains cable must all be connected to the side of the dishwasher as there is no space for them behind the appliance. 2 connection pieces 45° or straight, outer ø 19 mm, length 30 mm doublevalve waterdrainage waterinlet waterinlet mains cable watermains socket drainage mains cable 39 Warranty conditions Great Britain Standard guarantee conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: · The appliance has been correctly installed and used only on the electricity or gas supply stated on the rating plate. · The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's operating and maintenance instructions. · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. [. . . ]