User manual AEG-ELECTROLUX L50610

[. . . ] LAVAMAT 50610 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Useful tips and hints Environmental information 2 Contents Operating Instructions. 35 4 Operating Instructions 1 Safety Prior to using for the first time · Follow the "Instructions for installation and connection". [. . . ] Remove any rust deposits on the drum with a cleaning agent for stainless steel. Run a washing cycle without any washing to clean off any cleaning agent residues. 1/4 measuring cup of washing powder. Door and rubber collar Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door. Clean the glass in the door and the rubber collar regularly. 18 What to do if. . . Remedying minor malfunctions yourself If the programme progress display shows one of the following error messages during operation: ­ (END) flashes 1x (problem with water inflow), ­ (END) flashes 2x (problem with water outflow), ­ (END) flashes 4x (door open), please refer to the following table. For other error messages (one or more flashing indicators in the programme progress display): Switch the appliance off and then on again. If the error is displayed again, please contact customer service. Problem Possible cause Mains plug not plugged in or fuse not working. Press the (START/ PAUSE) button for longer. Child safety device has been Deactivate the child safety activated. Adjust the feet as described in the installation and connection instructions. The (END) indicator flashes 1x. (Problems with water inflow) The filter in the screw connection on the inlet hose is blocked. Water tap is furred with lime scale or is faulty. The transportation lock has not been removed. The washing machine vibrates when operating The screw feet are not coror is not stable. rectly adjusted. 19 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. Screw connection on the in- Screw the inlet hose on let hose is leaking. Water is running out Drain pump cover is not from under the washing closed properly. Follow the manufacturer's instructions exactly when measuring out detergent. Remove any foreign objects from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. Fabric softener not rinsed in, w compartment for conditioners is filled with water. Fabric softener insert in the Clean the detergent drawer, compartment for conditioninsert the fabric softener ers is not correctly inserted insert firmly. or is blocked. 20 Problem Possible cause Remedy Wait until the (DOOR) indicator has gone out and the (END) indicator is illuminated. To remove washing: If water can be seen in the appliance, first drain the water before opening the door (see section "Carrying out an emergency drain"). Observe maximum loads. Door locked. The door cannot be opened when the washing machine is switched There has been a power cut. 2 minutes. Washing is very creased. Too much washing may have been loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. [. . . ] The rating plate is next to the doorway. Connecting to the water supply Permitted water pressure The water pressure must be at least 1bar (=10N/cm2 =0. 1MPa) and may be a maximum of 10bar (=100N/cm2 =1MPa). ­ If less than 1bar: Disconnect the appliance end of the inlet hose from the solenoid inlet valve and remove the flow meter. (In addition remove the filter using pointed pliers and take out the rubber gasket behind it. ) Re-insert the filter. Water inlet Attention!· An inlet hose is supplied and can be found inside the machine drum. [. . . ]