User manual AEG-ELECTROLUX L74800

[. . . ] LAVAMAT 74800 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Useful tips and hints Environmental information 2 Contents Operating Instructions. 11 11 11 13 13 14 14 14 14 14 14 15 15 15 16 16 16 Child safety device. [. . . ] In the event of other faults (E plus a number or a letter): Switch the appliance off and on again. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. Problem Possible cause Mains plug not plugged in or fuse not working. Make another selection. When a button is The selected function canpressed, Err appears in not be combined with the the multi-display. END indicator flashes 4x, at the same time an Door is not closed properly. END indicator flashes 1x, at the same time an acoustic signal sounds 1x. Water tap is blocked with limescale or faulty. Close door properly. Check the water tap and have it repaired if necessary. 19 Problem Possible cause Transport lock has not been removed. Remedy Remove transport lock. Washing machine vibrates when operating or is noisy. Adjust feet according to the Screw feet not correctly adInstallation and Connection justed. Mix large and small items. Washing has not been spun. Screw connection on the inTighten inlet hose. Water is leaking out un- Drain pump cover is not derneath the washing closed properly. At the Probably too much deterend of the washing cygent has been used. END indicator flashes 2x, at the same time an acoustic signal sounds Drain pump is blocked. (Problems with water outflow. ) With connection to sink outlet: sink outlet is blocked. Conditioner not rinsed in, w compartment for additives is filled with water. Close off emergency drain hose properly. Dose detergent exactly as instructed by manufacturer. Remove kink. Clean out sink outlet. Conditioner insert in the compartment for additives is not correctly attached or is blocked. Clean detergent dispenser drawer, insert conditioner insert firmly. 20 Problem Possible cause Door locked. Remedy Wait until DOOR indicator is lit green. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened Power cut. Door remains locked for 4 to 10 minutes. Washing is heavily creased. Possibly too much washing was loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum Too little detergent is being used. Washing soiled with ointment, grease or oil was washed with too little detergent. A common cause is that fabric conditioner especially a concentrate has got onto the washing. Such stains should be washed out as quickly as possible and make sure that you are careful when using fabric conditioner. Especially with dark colours it is advisable to use liquid detergents. 21 Carrying out an emergency drain 1 Warning! [. . . ] If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5. 02m (16. 5 ft) between the appliance's inlet and the bottom of the water storage tank. 31 Water drainage The maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre. The Customer Care Department stocks outlet hoses of different lengths. Draining water into a sink outlet Secure the outlet/sink outlet joint with a hose band clip (available from your dealer). 1 Draining water into a wash basin/bath Important! [. . . ]