User manual AEG-ELECTROLUX LAV51465

[. . . ] LAVAMAT 51465 ELECTRONIC Washing Machine User information Dear Customer, Please read this user information carefully. Pay particular attention to the section "Safety" on the first Info pages. Please keep this user information in a safe place for later reference. Pass it on to any future owners of the unit. 1 The warning triangle and /or signal words (Warning!, Caution!, Important!) emphasise information which is important for your safety or for the unit's functional reliability. [. . . ] Water could not be fully drained out before spinning because the drain hose is kinked or the water pump is blocked. Adjust the feet according to the Installation and Connection instructions. Check the drain hose and remove any kinks if necessary or clean the water pump and if necessary remove any foreign bodies from the pump housing. Close the cover correctly. Probably too much detergent has been used The screw connection of the inlet hose is leaking. The drain pump cover is not correctly closed. Water leaks out Stop the programme, remove of the washing maWashing is caught in the door. Close the emergency emptying hose (see Section "Carry The emergency emptying hose out emergency emptying"). Fabric softener was The insert in the conditioner not rinsed in, the compartment is not correctly compartment is attached or is blocked. Clean the detergent dispenser drawer and attach the conditioner insert correctly. 29 Operating Instructions Problem Possible cause Remedy Pay attention to the maximum load quantity (see Programme Tables). In the case of easycare fabrics, select the < (EASY IRON) programme. Always load the drum as ful as possible with a combination of large and small items. For pumping heights over 1 m a conversion kit is available as a special accessory. Wait until the programme has ended, the K (DOOR) light goes off and the L (END) light is lit. If it is necessary to open the door immediately, Turn the programme selector to I (OFF); then turn it to v (DRAIN). When the water has been pumped out, the door can be opened. Washing is heavily creased. Probably too much washing has been put in the drum. The washing has not been spun as dry as usual. The washing was not able to be distributed evenly in the drum prior to spinning. The maximum pump height (outlet height 1 m from the base of the appliance) is exceeded. Washing is not thoroughly spun, water remains visible in the drum. For siphon attachments: the siphon is blocked. The door cannot be opened when the washing machine Door is locked due to high is on. PAUSE) and K (DOOR) lights come on. 30 Operating Instructions Problem Possible cause Remedy The programme continues when power is restored. The failure may be caused by a blown house fuse or by a mains supply fault into the house. (For safety reasons, the door remains locked for around 2 minutes. ) If washing has to be taken out during a power cut: Turn the control knob to I (OFF). Carry out emergency emptying (see Section "Carry out emergency emptying"). After about 2 minutes, the door can be opened by pulling on the handle. Clean the filter. Power failure during a wash programme (all indicator lights are off). The water tap is not fully Remnants of deter- opened. [. . . ] Mustame tee 24 EE0006 Tallinn Tel. : (372) 6 650 090 Fax: (372) 6 650 092 Hongkong Wo Kee Services Ltd. Terlaton Street 42/44 1011 Riga Tel. : 371 2 297821 Fax: 371 2 821286 Lthuania Electrolux Lthuania Verkui 29 2600 Vilnus Tel. : 372 272 3326 Fax: 372 272 3366 Poland Electrolux Poland Sp. Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 48 Warranty conditions / Customer service centres Israel Electricity & Electronic Services-Evis LTD. [. . . ]