User manual AEG-ELECTROLUX LAVAMAT 50212

[. . . ] LAVAMAT 50212/50612 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Useful tips and hints Environmental information 2 Contents Operating Instructions. 35 4 Operating Instructions 1 Safety Prior to using for the first time · Follow the "Instructions for installation and connection". [. . . ] Adjust the feet as described in the installation and connection instructions. The (END) indicator flashes 1x. (Problems with water inflow) The filter in the screw connection on the inlet hose is blocked. Water tap is furred with lime scale or is faulty. The transportation lock has not been removed. The washing machine vibrates when operating The screw feet are not coror is not stable. rectly adjusted. 19 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. Screw connection on the in- Screw the inlet hose on let hose is leaking. Water is running out Drain pump cover is not from under the washing closed properly. Follow the manufacturer's instructions exactly when measuring out detergent. Remove any foreign objects from the pump housing. Drain pump is blocked. For sink spigot connections: Clean the sink spigot. Fabric softener not rinsed in, w compartment for conditioners is filled with water. Fabric softener insert in the Clean the detergent drawer, compartment for conditioninsert the fabric softener ers is not correctly inserted insert firmly. or is blocked. 20 Problem Possible cause Remedy Wait until the (DOOR) indicator has gone out and the (END) indicator is illuminated. To remove washing: If water can be seen in the appliance, first drain the water before opening the door (see section "Carrying out an emergency drain"). Observe maximum loads. Door locked. The door cannot be opened when the washing machine is switched There has been a power cut. 2 minutes. Washing is very creased. Too much washing may have been loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. · Washing soiled with ointment, grease or oil was washed with too little detergent. · A common cause is that fabric conditioner ­ especially a concentrate ­ has got onto the washing. Such stains should be washed out as quickly as possible and make sure that you are careful when using fabric conditioner. · Modern detergents may create foam even in the last rinse cycle. · This is due to the insoluble ingredients in modern detergents. Especially with dark colours it is advisable to use liquid detergents. Before emergency draining, switch off the washing machine and remove the mains plug from the socket. [. . . ] Should this occur, turn the water tap off and refer to your Service Centre to replace the hose. 31 Water drainage The maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre. The Customer Care Department stocks outlet hoses of different lengths. Draining water into a sink outlet Secure the outlet/sink outlet joint with a hose band clip (available from your dealer). 1 Draining water into a wash basin/bath Important! [. . . ]