User manual AEG-ELECTROLUX LAVAMAT 620

[. . . ] . . . 1 3 2 This symbol gives you additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover symbol. If you require assistance or advice on your appliance, please contact our customer care department by letter or telephone: Customer Care Department AEG Domestic Appliances Limited P. O. Box 47 Newbury Berkshire RG 14 5XL Tel: 01635 572700 Fax: 01635 42970 Printed on environmentally friendly paper. [. . . ] Do not use household furniture polish or abrasive cleaners to clean the panel and operating parts. Pull the detergent dispenser drawer out as far as it will go. The detergent dispenser drawer should be cleaned from time to time. 2. Clean the entire compartment area of the washing machine with a brush. Set the detergent dispenser drawer into the guide tracks and push in. Washing Machine Drum The washing machine drum is made from rust-free stainless steel. Any objects left in the laundry which are likely to rust can stain the drum. Do not clean the stainless steel drum with descaling agents containing acids, scouring agents containing chlorine or iron or steel wool. (Part no: 899 646 401 5214) Remove rust stains on the drum with a stainless steel cleaning agent. 0 Door 0 Regularly check if there are deposits or foreign bodies in the rubber seal behind the door and remove them. 27 Operating Instructions What to do when 3 The whistling noise when spinning may be different to your prevous washing machine which is due to the modern drive system. Trouble Shooting If you call out an engineer and the fault is listed here, a charge is levied even if the appliance is in guarantee. If the error code (1, (2 or (d is displayed in the multi-display, check the troubleshooting guide below before calling an engineer. If the error code is displayed again, please contact your local AEG Service Force Centre For all other errors displayed in the multi-display, please contact your local AEG Service Force Centre, stating the error code. Malfunction Possible Cause Remedy Mains plug is not plugged in. Unscrew the hose from the tap, remove the filter and clean under running water. If there are white residues on the washing These are insoluble contents of modern washing powders. Review your choice of powder, possibly use liquid detergents. 31 Operating Instructions Carrying out an Emergency Emptying If the washing machine no longer pumps out the water an emergency emptying must be carried out. If the washing machine is located in a room in which below freezing temperatures might occur, emergency emptying must be carried out if danger of freezing occurs. Furthermore, the inlet hose must be disconnected from the tap, drained and laid on the floor. Switch the washing machine off and pull the mains plug prior to emergency draining. Pull down the flap in the left corner of the base strip and remove it. 1 3. Undo and remove the plug in the end of the emergency emptying hose by turning it anti-clockwise and pull it out. Depending upon the amount of water, it may be necessary to empty the container several times. Temporarily close the emergency emptying hose with the plug. 32 Operating Instructions When the Water is Completely Drained: 7. Push the emergency emptying hose back in a little and let it catch on to the holder. Put on the flap and close. 3 The ÖKO lock does not function when the machine has been fully emptied. [. . . ] Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 1 WARNING!A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. 45 Installation and Connection Instructions Permanent Connection In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. ; This appliance is in accordance with the following EU Guidelines: Low Voltage Guidelines 73/23 EEC dated 19 February 1973, include Guideline Change Notice 93/68 EEC EMC Guideline 89/336 EEC dated 3 May 1989, including Guideline Change Notice 92/31 EEC. [. . . ]