User manual AEG-ELECTROLUX RC1600

[. . . ] You must read them carefully before installing or using the appliance!Children should not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician. This product should be serviced by an authorized Service Engineer, and only genuine spare parts should be used. [. . . ] Cleaning Before initial use and after defrosting or before prolonged periods of disuse, clean the unit containers and lid with lukewarm water and, if necessary, washing-up liquid. Warning: do not inadvertently press or force the opened lid past its stop-point (this could cause the hinges to break). A/C operation Do not use any additional form of energy (batteries/gas). Check that the supply voltage and line voltage data correspond to the type-plate on the back of the unit. (The following instructions refer in the main to coolers manufactured in the United Kingdom). The mains lead of your mobilCooler is fitted with a non-rewirable, moulded-on, 13-amp plug containing a 3-amp fuse. It is a regular earthed plug for connection to a regular earthed socket. Due to the difference in the plugs used, an adapter will be necessary for other countries. If the fuse requires replacing at any time, the fuse cover/carrier should be removed using a small screwdriver to lever it out. The old fuse should be replaced by a 3-amp, ASTAapproved, BS 1362 fuse and the fuse cover/carrier must be refitted before the plug is used again. If the fuse cover/carrier is lost, a replacement can be obtained from the Electrolux Service shops and offices. When using battery operation, the cooling performance is not thermostatically regulated, i. e. Only units exclusively equipped for use with one of the two electrical operation methods - A/C or D/C - can, in general, be thermostatically regulated by using knob A in the relevant operation method. When knob A is ineffective or if the temperature is unnecessarily too low: Turn unit off Pull out plug from socket. 8. Liquid gas operation Do not use any additional form of energy (mains/battery). The mobilCooler is equipped for a specific gas-pressure, corresponding to the standard pressure of the country in which it is sold. It is important that a non-adjustable pressure regulator is used to reduce the pressure in the gas cylinder to the operating pressure specified on the rating-plate, no other pressure may be used. Needle valve operated gas control taps are NOT suitable for use with this appliance and must not be used as a substitute for a pressure regulator. 9. Connection of gas supply (The following instructions refer in the main to coolers manufactured in the United Kingdom. For other countries please refer to your supplier. ) Always connect in the following sequence: GAS BOTTLE PRESSURE REGULATOR APPLIANCE. To connect the appliance to the pressure regulator an APPROVED GAS TUBING should be used. This should be minimum in length-have an inside dimension of 8mm and be marked BS3212/2/8. The pressure-regulator must be compatible for Butan 11 in (28mbar) or for Propane(37mbar). 34 GB Seal To connect the pressure-regulator to the gas bottle, the valve of gas bottle must be closed. After connecting the pressure-regulator to the bottle by screwing, connect the two ends of the tubing to the nipples and secure them with the two hose clipse. [. . . ] When it becomes necessary to replace the gas filter, remove the filter from the duct and replace it with a new one. Any other maintenance and repair works, especially those relating to the cooling aggregate and the gas-burner system, may be undertaken only by authorized customer service points. Recommendation: for your own safety you should have the complete gas system (burner and all connection parts) inspected every two years by an authorized service centre. 18. After-sales service Should a problem arise with the unit, please check the following before contacting a customer service: is the unit suitably placed and is it well ventilated? [. . . ]