User manual AEG-ELECTROLUX RM4200

[. . . ] MANUAL CARAVAN RM 4200 RM 4201 RM 4210 Rm 4211 Deutsch English Français Italiano Español Seite page page pagina pagina 1 7 13 19 25 Svenska Dansk Norsk Nederlands Suomi Português sida side side pag. 08/00 OPERATING AND INSTALLATION INSTRUCTIONS FOR ELECTROLUX REFRIGERATORS INTRODUCTION We are pleased that you have chosen this refrigerator and hope you will derive much satisfaction from using it, but first a few well-meant words of advice: It is important to read through these instructions carefully before using the refrigerator. To ensure good refrigeration and economical operation, the refrigerator must be installed and used as described in these instructions. The refrigerator is designed for building-in to leisure vehicles such as caravans or motorhomes. [. . . ] the refrigerator fails to work on 12 V, check: That the 12 V supply is connected to the refrigerator. If the refrigerator fails to work on 230 V, check: That the 230 V supply is connected to the refrigerator. The ventilation is inadequate owing to reduced area of the ventilation passages (partial blockage of grilles from wire mesh etc). The gas pressure is incorrect - check the pressure regulator at the gas container. DEFROSTING Frost will gradually accumulate on the refrigerating surfaces. It must not be allowed to grow too thick as it acts as an insulator and adversely affects refrigerator performance. Check the formation of frost regularly every week and when it gets about 3 mm thick, defrost the refrigerator. To defrost the `fridge, turn it off and remove the ice tray and all food items. Warning: normally the temperature of items of fozen foods would rise unduly during defrosting and so they should be consumed within 24 h or discarded. Do not try to accelerate defrosting by using any kind of heating appliance, as this might damage the plastic surfaces of the refrigerator. The defrost water runs from a collector channel to a receptacle at the rear of the refrigerator where it evaporates. Defrost water in the freezer compartment should be mopped up with a cloth. Place the food items back inside but wait until the refrigerator is cold before making ice cubes. 5. The door is not properly closed or the magnetic sealing strip is defective. If the refrigerator still does not work properly, call a service technician. The sealed cooling system must not be opened, since it is under high pressure. TECHNICAL DATA Overall dimensions, refrigerator Height Width Depth (incl. cooling unit) without door with door Build-in dimensions Height Width Depth Capacity gross net frozen food compt Weight (without packaging) Electrical data Input 230 V 12 V Energy consumption /24 h LP gas data Input ditto, low flame Energy consumption /24 h Cooling medium Ammonia (R 717) RM 42XX 618 mm 486 mm 435 mm 474 mm 620 mm 490 mm 450 mm 60 51 6 21 lit. kg MAINTENANCE Concerning gas- and electric installations, only authorized experts are allowed to carry out maintenance and repair works. The dimensions of the panel must be: 532 mm 453 mm max 3, 8 mm Remove the door, see REPOSITIONING THE HINGES. Remove the lower trim moulding and then withdraw the panel by sliding it downwards. Fit the trim moulding back in place. BUILDING-IN Ventilation grilles Fig. 2 The refrigerator is intended for installation in a caravan or motorhome, and the description relates to this application. The refrigerator must not be exposed to radiated heat from hot objects (e. g. [. . . ] PUSH-ON CONNECTIONS MUST NOT BE USED (We do not approve the use of "rubber" type flexible tubing for connecting permanently operating appliances of this type in the United Kingdom). should be of a type specifically designed for the type and diameter of the connection pipe used, and screwed joints should be sealed with a joining compound approved for use with bottled gas. The gas supply pipe should be connected to the gas inlet pipe on the right hand side of the gas control valve by means of a suitable threaded compression coupling. In making the connection to the refrigerator, a gas cock of an approved type for use LPG must be incorporated in the supply line in a position which is readily accessible to the user. [. . . ]