User manual AEG-ELECTROLUX T56800

[. . . ] LAVATHERM 56800 Condenser dryer User information Dear Customer, Please read this user information carefully and keep it to refer to later. Please pass the user information on to any future owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning!Useful tips and hints Environmental information 2 Contents Operating Instructions. 5 5 6 7 8 8 9 9 12 12 12 12 12 13 13 13 13 13 14 14 14 15 15 16 17 18 19 19 Overview of programmes . [. . . ] Conductance of water at installation site differs from standard setting of machine. Re-programme standard setting for degree of drying (see `Programming options' section). Fine strainer not in place Install fine strainer and/or Loading door does not and/or large mesh filter not snap large mesh filter into close. When pressing a button, the corresponding button flashes several times. After the start of the programme, Turn the programme knob to the option can no longer be OFF. Empty condensate tank, then start programme with START/ PAUSE button. Condensate tank is full. Select time programme or Not enough washing loadhigher drying level (e. g. INTENed or washing loaded is too SIVE DRY instead of STORAGE dry for selected programme. DRY). 20 Problem Possible cause Lint filter clogged. Remedy Clean lint filter. Note: After up to 5 hours the drying cycle finishes automatically (see "Drying cycle complete"). Heat exchanger clogged with lint. SPECIAL CARE button SPECIAL CARE is only suitable pressed and load volume too for use with loads of up to big. Laundry must be adequately spun. Changing bulb for interior light 1 1 Only use a special bulb which is designed specially for dryers. These develop too much heat and may damage the machine! 1 Warning!Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully remove the fuse. Unscrew the lampcover (this can be found directly behind the loading aperture, at the top; refer to "Description of machine" section. ) 2. For reasons associated with safety, the lampcover must be screwed down tightly. If this is not done, the dryer must not be operated. 21 Programming options Objective Permanently programme in the audible signal which reminds you that the programme is complete. Press the AUDIBLE SIGNAL and SENSITIVE buttons at the same time and hold down for approx. Adjust 'level of dryness' The current setting is displayed on the programme detection: progress display: If the laundry is slightly ­ END display: Setting for drier laundry drier or slightly damp­ COOLING display: Standard setting er at the end of the ­ DRYING display: Setting for damper laundry programme than with 3. Press the START/PAUSE button until the setting required the standard setting. Press the DELAY TIMER and SPECIAL CARE buttons at the TY WATER display when same time and hold down for approx. for the condensed waThe EMPTY WATER display is permanently deactivated. Settings may be cancelled as under 1 and 2, but the EMPTY WATER display is briefly illuminated (instead of flashing). 22 Technical data 5 This appliance conforms with the following EU Directives: ­ 73/23/EEC dated 19. 02. 1973 Low Voltage Directive ­ 89/336/EEC dated 03. 05. 1989 EMC Directive inclusive of Amending Directive 92/31/EEC ­ 93/68/EEC dated 22. 07. 1993 CE Marking Directive Height x width x depth Depth with loading door open Height can be adjusted by Weight when empty Loading volume (depends on programme) 1) 85 x 60 x 60 cm 109 cm 1. 5 cm approx. (6kg of cotton, pre-drained at 1000 rpm, 3. 7kWh COTTONS STORAGE DRY programme) Use permissible ambient temperature Domestic + 5°C to + 35°C 1) Different loading volume data may be needed in some countries as a result of different measuring methods. Consumption values The consumption values have been established under standard conditions. They may deviate when the machine is operated in domestic circumstances. Programme COTTONS STORAGE DRY 1) COTTONS HAND IRON 1) 2) Loading volume in kg 6 6 3 Energy consumption in kWh 3, 70 3, 00 1, 35 EASY CARES STORAGE DRY 1) pre-drained at 1000 rpm 2) pre-drained at 1200 rpm 23 Installation and connection instructions 1 Installation safety instructions · Before first starting up, all parts of the transport safety devices must be removed. [. . . ] 10 Rothwell Avenue Albany - Auckland 4399 Auckland 1 New Zealand Tel. : 00 64-92 59 11 11 Fax: 00 64-92 59 11 12 Syria WATTAR CO. Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Bulgaria Electrolux Bulgaria E. O. O. D. Box 21587 Nicosia 1511 Service Telephones: Nicosia 02 481226 Limassol 05 562182 Larnaca 04 633929 Paphos 06 932 699 Estonia Electrolux Estonia Ltd. [. . . ]