User manual AEG-ELECTROLUX T88800

[. . . ] LAVATHERM 88800 User manual Pro Steam Condenser Dryer 2 Dear Customer Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] When the option is active, the DELICATE SENSITIVE For gentle drying of fabrics that are frequently worn. Programme starts on full heat setting, which is then reduced as the programme progresses to be kind to the washing. When the option is active, the SENSITIVE 2) available with cotton/easy care and cotton/synthetic shirts programmes 32 LONG ANTI-CREASE A 90 minute anti-crease phase is set. If this additional option is selected, the anti-crease phase (30 min. ) at the end of the drying cycle is lengthened by 60 minutes. The laundry can be removed at any time during the anti-crease phase. BUZZER The appliance is supplied with the BUZZER function deactivated. When the function is active, the BUZZER symbol appears in the display. The buzzer sounds or plays a tune during: ­ cycle end ­ anti-crease phase and when phase starts or ends ­ cycle interruption by a warning ­ alarm CHILD LOCK The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. The child safety device can be deactivated by holding down the OPTION and OK buttons simultaneously for 5 seconds. ­ Before programme is started: appliance cannot be used ­ After programme is started: programme in operation cannot be changed icon appears in the display to indicate that the child lock is The child lock activated. If you want to set a new programme, you must first deactivate the child lock. SPIN SPEED If the washing in the washing machine was initially drained prior to the drying cycle, the dryer can be set according to the spin speed of the initial drainage procedure. The higher the spin speed was, the shorter the programme length for the drying cycle. Activate the SPIN SPEED option and then number of times press OPTION button until the desired spin speed of the initial drainage is displayed. No value is shown if no spin speed is selected. 33 In certain programmes the spin speed has not effect (time controlled cycles), its selection can be not selectable and only three dashes are visualized. Available selections: from 800 to 1800 rpm's in 100 rpm's intervals. The maximum value depends by selected program, the minimum is always 800 rpm For those programs where the spin speed has no effect (time controlled cycles), the selection is not allowed and three dashes "- - -" are displayed that has the meaning of not set or unknown. The user interface always remembers last spin selection, and proposes it as default for all new selected programs. If memorized spin speed is greater than maximum allowed value it will be automatically reduced to max spin speed available for the selected program. Selecting TIME (TIJD PROGR. ) To select the programme duration after setting the TIME programme. You can select a programme duration from 10 minutes to 3 hours in 10-minute steps. The 0:10 minutes is in the display (corresponding to the COOLING programme). Press the TIME button repeatedly until the desired programme duration is shown in the display, e. g. If the programme duration is not selected, the duration is automatically set to 10 mins. Selecting DELAY START (STARTUITSTEL) See chapter Pro Steam system, section Selecting DELAY START (STARTUITSTEL). Starting the drying programme Press the START PAUSE (START PAZUZE) button. The progress bar and the name of currently performed phase, above it, show stage of the cycle. [. . . ] Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. [. . . ]