User manual AEG-ELECTROLUX ZCV782

[. . . ] If no visual obstruction can be detected, disconnect the cleaner from the power receptacle and contact your nearest Electrolux service location. 8 Instruction Manual (Swedish) (Danish) (Norwegian) (Finnish) P/N 460332 SVERIGE Electrolux Central Vacuum Systems 4. 5. Rotate the bag collar 45° counter clockwise so the bumps on the adapter DO NOT align with the collar bump cutouts. To remove, rotate the bag collar 45° clockwise and gently lower the collar off of the bag adapter. Cloth Filter Cleaning (ZCV782, ZCV783, ZCV784) NOTE: Disconnect power cord from electrical outlet before cleaning the filter. [. . . ] To remove the paperbag filter, detach the lid of the power unit by twisting it and removing it. A new filter paperbag is put in place and the lid securely attached again with a twist movement. Be sure the paperbag and the lid are securely attached to avoid any suction and dirt leakage. Filter and Disposable Paper Bag Reduced airflow or suction indicates the central vacuum cleaner is not operating at maximum efficiency. If the disposable paper bag is full or a filter is clogged, no air can pass through the unit and no cleaning will take place. Remove and dispose of the paper bag. Do not operate this unit without all filters in place. Optional DISPOSABLE PAPER FILTER BAG WITH CLOTH FILTER (cannot be used with dual intake/intake-utility installations) NOTE: Disconnect power cord from electrical outlet before cleaning the filter. The elbow with the paper bag adapter must be installed, in the body facing downward as shown for the paper bag. Using pipe clamp, attach 90º sweep with bag adapter to 45º intake fitting as shown. Hold the bag collar with fingertips and align the bumps on the adapter with the bump cutouts in the collar. Insert adapter and push the bag collar all the way up to the lip on the elbow. SAVE THESE INSTRUCTIONS 1 6 Grounding Instructions This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor. The cord must be connected to an appropriate circuit that is properly installed and grounded in accordance with all local codes and ordinances. (The Model ZCV781 is double insulated, therefore not applicable. ) Connect the two low voltage terminals, as shown in Figure A, to the power unit and to the wires installed with the main trunk line. Be certain you comply with your local electrical codes and regulations. Plug the cord into a grounded receptacle as shown and into the power unit control module as shown in figure B. WIRING: Check local codes but use not less than #14-2 with ground wire. · · · · · Plug the hose into each inlet valve to be sure the electrical contacts operate properly. Be sure the paper bag and filters are properly installed in the power unit. [. . . ] Never vent into a wall, a ceiling or a concealed space in the house. 10. 5 kg 1200W 28 kPa 10A Paper bag 64 dB(A) 518 AW 1200W 28 kPa Figure A 4 Figure B 3 Dirt Capacity - Dirt Bucket/Bag Hang the power unit. Align the power unit intake fitting to the main trunk line projecting from the wall and the exhaust port to the outdoor exhaust pipe. Never vent into a wall, a ceiling or a concealed space in the house. Self-cleaning Filter/Dirt Canister No Disposable Paperbag Dimensions HxW Weight (boxed) Specifications Circuit Breaker Max Water Lift Max Air Flow Max Airwatts Motor Effect Noise Level Electricity Insulation Filtration Motor 31 liter 50 l/s 230V IP 24 9 kg 10A Yes Compare the distance between the power unit mounting bracket and the wall stud in the chosen mounting location. If the mounting bracket cannot be mounted on the stud, it is suggested you use a length of board mounted horizontally to the studs. [. . . ]