User manual AEG BS2E 14.4 T
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG BS2E 14.4 T. We hope that this AEG BS2E 14.4 T user guide will be useful to you.
Manual abstract: user guide AEG BS2E 14.4 T
Detailed instructions for use are in the User's Guide.
[. . . ] j Use only System 3000 chargers for charging System 3000 battery packs. The following battery packs can be charged with this charger: voltage battery 7, 2 V 9, 6 V 12 V B 7. J No metal parts must be allowed to enter the battery section of the charger (short circuit risk). J Never break open battery packs and chargers and store only in dry rooms. [. . . ] Switch trigger for switching the machine on and off, and for smooth starting and varying speed. QUICKSTOP the speed of the working spindle is immediately reduced when releasing the switch. Reversing lever for changing from forward to reverse rotation due to a lockout mechanism, switching the lever is only possible if the On-/Off switch is not depressed. Powerful battery pack with reverse battery protection, negative and positive pole cannot be mistaken. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. The chuck is easier to remove when 1st gear is engaged as the gears tend not to rotate as easily. Battery pack Battery pack reception (only applicable for BS2E 12 T BS2E 14. Fully charge new or long stored battery packs before using your battery tool. Insert the battery pack from behind into the machine until it engages (as shown in illustration). The battery pack can be inserted either way into the holding device: From the front: The shape of the machine is more compact and therefore well suited for working in restricted space. From the back: Due to the optimum weight distribution the machine is ideally balanced. Press together the clamps and remove the battery pack in direction of arrow. Due to a lockout mechanism, the reversing lever can only be switched when the On-/off switch is not depressed. The gears can be changed when the machine is switched off or is running under no load. Switching on: Press on-off switch Switching off: Release on-off switch The speed can be infinitely varied by slowly releasing/pressing the switch trigger. For drilling twist the adjustment ring such faces the marking; the that the symbol safety clutch is now locked and the maximum torque available. For screwdriving at constant cutting depth torque speed preselection with torque adjustment ring is possible. For this turn torque adjustment ring until the desired torque level faces the marking. [. . . ] After warming up of the battery charging takes up automatically; the battery can stay in the charger. The battery can be stored permanently in the charger without the danger of being overcharged. The battery charger can be used either standing up or fixed to a wall (see illustration). Battery too cold (less than 0oC) Maintenance charging until battery temperature is above 0oC Battery too hot (over 45oC) Maintenance charging allow battery to cool down below 45oC, and re-insert New battery packs reach full loading capacity after 4 5 chargings and dischargings. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG BS2E 14.4 T
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG BS2E 14.4 T will begin.