User manual ALPINE CHA-S634

[. . . ] Installation of Changer With the CHA-S634, CDs are automatically removed from and reinserted into the CD magazine, DO NOT mount the unit upside down, as this could cause the mechanism to become misaligned. Failure to make the proper connections may result in fire or product damage. When drilling holes in the chassis for installation, take precautions so as not to contact, damage or obstruct pipes, fuel lines, tanks or electrical wiring. dO NOT USE BOLTS OR NUTS IN THE BRAKE OR STEERING SYSTEMS TO MAKE GROUND CONNECTIONS. [. . . ] You can play CD-Rs (CD-Recordable)/CD-RWs (CD-ReWritable) for audio use on this unit. Some of the following CDs may not play on this unit: Flawed CDs, CDs with fingerprints, CDs exposed to extreme temperatures or sunlight (e. , left in the car or this unit), CDs recorded under unstable conditions, CDs on which a recording failed and a re-recording was attempted. Use discs with MP3 files written in the format compliant with ISO 9660 level 1 or level 2. You may not be able to use some MP3 functions, such as FOLDER UP/DOWN on this system. With Mini-BUS System 6 8 pin DIN Input Connector 7 M-Bus/Ai-NET Compatible Cable (KCA-130B sold separately) G Cautions for Connections · Head unit with Ai-NET capability and Ai-NET Cable (Fig. Heat and humidity may damage the CD and you may not be able to play it again. The higher the bit rate, the higher the sound quality, but also the larger the files. Use the hexagon washer-head bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Changer. This value shows how many times per second the data is sampled (recorded). 1 kHz, so the sound level is sampled (recorded) 44, 100 times per second. The higher the sampling rate, the higher the sound quality, but also the larger the volume of data. Converting music CDs, WAVE (AIFF) files, and other sound files into the specified audio compression format. Do not allow any cables in the vehicle to come into contact with the unit. It is possible, the constant vibration and movement in the vehicle can cause the cable's insulation to wear through. Song information such as track titles, artist names, album names, etc. When connecting to an Ai-NET head unit produced before December 2001 or Mini-BUS head unit, the track No. Thus, after 100th track (file), the actual number and number displayed will be different. Operation of MP3 DATA through combining connected head unit When connected to an Ai-NET head unit produced before December 2001 or Mini-BUS head unit, operations of MP3 DATA such as "folder UP/DOWN" cannot be performed. Displaying MP3 data when connected to the head unit When connecting to the Ai-NET head unit produced before December Attach the "L" type brackets to both sides of the Changer with hexagon washer-head bolts (M4x8). 6mm diameter tip and firmly mount brackets with hexagon flange-head bolts (M6x 50) and hexagon flange-head nuts (M6). (nothing is displayed if a disc does not have any folders, or has character codes not compatible with MP3. [. . . ] NOTE: Due to product improvement, specifications and design are subject to change without notice. For the North American Customers IMPORTANT NOTICE This Compact Disc Changer has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules. This equipment generates and uses radio frequency energy, and it must be installed and used properly in accordance with the manufacturer's instructions. This device can not correctly play back discs recorded with packet writing. [. . . ]