User manual AMERICAN AUDIO DX4

[. . . ] MIC 1 MASTER LEVEL LEFT RIGHT PHONO 1 PHONO 2 LINE 3 LINE 5 LINE 1 LINE 2 LINE 4 LINE 6 +5 0 -5 -10 -15 -15 -10 -5 0 +5 POWER 0 10 MIC 1 VOLUME 5 5 5 5 5 5 5 5 0 10 0 10 0 10 0 10 BASS MID LOW MID HIGH TREBLE CUE CUE CUE CUE 0 10 0 10 MIC 2 VOLUME MASTER LEVEL 0 10 CUE PGM 0 10 ASSIGN CH ASSIGN CH BOOTH LEVEL CUE MIXING CUE LEVEL PHONES DX4 TM Professional Preamp Mixer 4295 Charter Street Los Angeles Ca. 90058 www. americandj. com AMERICAN AUDIO DX4TM Unpacking Every DX4TM has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage that may have occurred during shipping and be sure all accessories necessary to operate the unit have arrived intact. [. . . ] BOOTH LEVEL (BOOTH LEVEL VOLUME CONTROL) - This rotary knob is used to control the output volume to any source connect to the BOOTH OUTPUT JACKS (25) on the rear of the unit. Be sure this volume control is always set to zero before turning the unit on and off. CUE MIXING CONTROLLER - This knob is used to select the monitoring source, either the master output or a channel. The cue level is prefader and is not affected by a channel's fader level. To monitor the master output signal turn the knob to the "PGM" position to monitor a channel signal turn the knob to the "CUE" position. To vary the amount of either signal turn the knob more or less to the center position. If the knob is set to the center position, you can monitor both the cue and master output levels equally. CUE LEVEL VOLUME CONTROL - This knob adjusts the headphone volume output level. Turning the knob in clockwise direction will increase headphone volume output. HEADPHONE JACK - This jack is used to connect your headphones to the mixer allowing you to monitor the cue source. Always be sure the CUE LEVEL VOLUME (12) is set to minimum before you put the headphones on. ©American Audio® - www. americandj. com - DX4TM Instruction Manual Page 6 DX4TM Controls and Features Cont. Rear Panel 17 18 19 20 21 22 23 24 22 AMERICAN AUDIO PREAMP MIXER MODEL NO. DX-4 AC 18V ~ 50/60HZ 20W CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS:RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR. 25 26 27 28 29 30 31 17. POWER CONNECTION - This connector is used to supply main power to the unit via the included detachable power adaptor. Do not attempt to force a cord in if it does not fit, be sure the cord is being inserted properly 18. BALANCED XLR MASTER OUTPUTS - The Master Output includes a pair XLR Balanced JACKS as well as a pair RCA UNBALANCED JACKS (19). These jacks should be used when you will be driving an amp or other audio equipment with a balanced input, or whenever you will be running a signal line greater than 15 feet. RCA MASTER OUTPUTS - The Master Output includes a pair XLR BALANCED JACKS (18) as well as a pair RCA Unbalanced Jacks. These jacks should only be used for shorter cable runs to signal processors or looping to another mixer. CHANNEL 4: LINE 6 INPUT JACKS - These Jacks are used for line level inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. CHANNEL 3: LINE 4 INPUT JACKS - These Jacks are used for line level inputs. [. . . ] All returned service items whether under warranty or not, must be freight pre-paid and accompany a R. A. (return authorization) number. If the mixer is under warranty, you must provide a proof of purchase invoice. number by contacting our customer support team on out toll free number. DX4TM Main Features 2-YEAR LIMITED WARRANTY A. American Audio® hereby warrants, to the original purchaser, American Audio® products to be free of manufacturing defects in material and workmanship for a period of 2 Year (730 days) from the date of purchase. [. . . ]