User manual AMERICAN AUDIO Q-D5 MK2

[. . . ] 90040 www. AmericanAudio. us Q-D5 MKIITM Unpacking Every Q-D5 MKIITM has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment necessary to operate the mixer has arrived intact. In case damage has been found or parts are missing, please contact our toll free customer support number for further instructions, please do not return the mixer to your dealer. Q-D5 MKIITM Introduction Introduction: Congratulations and thank you for purchasing the American Audio® Q-D5 MKIITM mixer. [. . . ] These controls are used to increase or decrease the LOW's, MID's, and HI's of the output signal. CHANNEL trEbLE CoNtroL - This knob is used to adjust the treble levels of a channel allowing for a maximum treble gain of 15dB or maximum decrease of -30dB. Turning the knob in a counter-clockwise direction will decrease the amount of treble applied to a channel signal, turning the knob in a clockwise direction will increase the amount of treble applied to a channel signal. CHANNEL MIDrANgE CoNtroL - This knob is used to adjust the midrange levels of a channel allowing for a maximum midrange gain of 15dB or maximum decrease of -30dB. Turning the knob in a counter-clockwise direction will decrease the amount of midrange applied to a channel signal, turning the knob in a clockwise direction will increase the amount of midrange applied to a channel signal. CHANNEL bASS CoNtroL - This knob is used to adjust the low frequency levels of a channel allowing for a maximum bass gain of 15dB or maximum signal decrease of -30dB. Turning the knob in a counter-clockwise direction will decrease the amount of bass applied to a channel signal, turning the knob in a clockwise direction will increase the amount of bass applied to a channel signal. db Meter MODe seLeCtOr - This push button switch is used to change the operating mode of the dB LED meter. When the switch is in the Master L/R (up) position, the dB meter will indicate the master output levels. When the switch is in the PFL CH1/CH2 (down) position the dB meter will use the left side of the meter to indicate channel one's prefader level and use the right side of the meter to indicate channel two's prefader level. Q-start On/OFF sWItCh - This function works in conjunction with a compatible American Audio® or American DJ® "Q" Start CD player. When used with a compatible CD player, you can use the crossfader to start and stop the CD play. The ON/OFF "Q" START switch activates the fader "Q" start feature. When the fader "Q" start feature is activated sliding the CROSSFAdER (1) from left to right will play or cue any CD player connected to the CONTROLLER jACKS (19) on the rear of the unit. For example, connect a compatible dual CD player connect to mixer channels one and two (refer to your CD player manual for proper set-up). Be sure the Fader "Q" Start feature is activated on both channels. Slide the crossfader to the channel one position (full left) and begin playback on CD drive one. This will immediately trigger the play function on CD drive two and return CD drive one to cue mode. To return to normal fader operation turn the Fader "Q" Start ON/OFF SWITCH to the OFF position. ©American Audio® - www. AmericanAudio. us - Q-D5 MKIITM Instruction Manual Page 7 Q-D5 MKIITM Controls and Features Cont. 17 18 19 20 21 AC IN- PLAYER CONTROL B A LIGHT CONTROL MIC OUTPUT L CH-2 CH-1 GND GND R MASTER REC LINE 2 PHONO 2 AUX 2 AUX 2 PHONO 2 LINE 1 PHONO 1 AUX 1 AUX 1 PHONO 1 22 23 24 25 26 27 28 29 30 17. AC CoNNECtIoN - This connector is used to supply main power to the unit via the included detachable power cord. Do not attempt to force a cord in if it does not fit, be sure the cord is being inserted properly 18. AC VoLtAgE SELECtor - This switch is used to adjust the operating voltage. [. . . ] All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R. A. ) number. number must also be written down on a piece of paper and included in the shipping container. If the unit is under warranty, you must provide a copy of your proof of purchase invoice. American Audio® hereby warrants, to the original purchaser, American Audio® products to be free of manufacturing defects in material and workmanship for a period of 1 Year (365 days) from the date of purchase. [. . . ]