User manual AMX AXB-PT1015 CAMERA BALANCING GUIDE

[. . . ] Camera Balancing Guide AXB-PT10/15 PosiTrack Camera Controllers IMPORTANT!READ THIS DOCUMENT BEFORE MOUNTING CAMERA Proper balance of the camera mount (with camera/lens/cradle) will result in optimal performance. [. . . ] Re-attach the camera mount (with camera/lens) to the cradle support bracket using the two 1/2" screws. Take the entire camera/mount and cradle assembly and align the lens with the Tilt Hub so that the vertical-axis intersects the center of the camera's iris, as shown in FIG. 4. Camera points in this direction 0. 56" 39. 62 mm Marker points Iris Vertical tilt-axis FIG. 1 Tilt Hub dimensions for the PT10/15 Caution: Do not lift the PT10/15 by the Camera/Lens cradle as this could damage internal components. Separate the camera mount and the cradle support bracket by removing the two 1/2" screws on the underside of the assembly (see FIG. Install the camera alignment peg to the mount at the position that best fits the camera/lens. Secure the camera/lens to the mount (at the camera alignment peg) with the 1/2" screw and 1/10" thick washer supplied (see FIG. Mounting holes (three sets) Cradle support bracket Camera\Lens cradle assembly (side view) (underside FIG. Mark the position of the cradle support bracket on the Tilt Hub (for later attachment). Remove the camera/lens and mount piece from the support bracket by unscrewing the two 1/2" screws on the underside of the camera mount. 2. Secure the support bracket to the Tilt Hub (at the same position marked for the iris alignment) on the PT10/15 with some or all of the four 1/2" screws and washers. Secure the camera/mount to the support bracket by using the two 1/2" screws. [. . . ] AMX reserves the right to alter specifications without notice at any time. 3000 RESEARCH DRIVE, RICHARDSON, TX 75082 · 800. 222. 0913 · 469. 624. 7153 · fax 469. 624. 7153 · technical support 800. 932. 6993 · www. amx. com 93-0630 REV: B [. . . ]