User manual ART SGX NIGHTBASS

[. . . ] SGX NIGHTBASS TABLE OF CONTENTS INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 GETTING STARTED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONNECTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The number displayed in the upper left corner represents the MIDI Controller you are working with. Performance MIDI has four levels of programming information associated with it broken up into 4 screens. The first screen displays the information to define what parameter the assigned MIDI controller will control. The LCD will display the MIDI control number and its description (i. e. Incidentally, the default value is MC 4 which happens to be the Left Foot Controller on the X15. The MIDI DataMONITOR may be selected for use in this screen to display MIDI data being sent. The third screen displays the LOW value (minimum value) of the parameter's range. The fourth screen displays the HIGH value (maximum value) of the parameter's range. These parameters may be "swapped" to make the value change in a reverse or opposite direction. Change the value until the bottom of the screen displays MIDI DataMONITOR. (turn the Encoder counterclockwise) You are allowed to change between MIDI controllers on the device you are sending MIDI data from (keyboards, X-15, etc. ) and view the corresponding data in this screen. The top half of the display will show the numerical value of the MIDI data being received by the NIGHTBASS. Displayed in the bottom half is the actual MIDI controller being used. When you change the controller, its MIDI data will be displayed in the top half of the LCD. Screen 1 #1 IS CONTROLING MIX:DRY = 0% Screen 3 #1 LOW VALUE: MIX:DRY = 0% Screen 2 #1 CONTROLLER IS MC 4:FOOT CTRL. Screen 4 #1 HIGH VALUE: MIX:DRY = 100% DESCRIPTION OF ALGORITHMS The NIGHTBASS offers over seventy effects selections for you to choose from. Each effect may have several types to select for specifically narrowing down the particular sound you are looking for. These are: Analog Effects, Signal Frequency Shaping, Swept or Modulated Effect, Natural Reverberation, Gated Reverberation, Delay, and Utility/Level. Rather than tell you which effects cannot be combined, the NIGHTBASS automatically selects 21 (or defaults) to which algorithms may be combined and displays them in the LCD when you are "ADDing an EFFECT". All of the analog and digital effects parameters including the Mix Control parameters are controllable via the X-15. Some parameters were specifically tuned to be used with foot controllers. These are: the compressor output, envelope filter tuning, any threshold, attack, release or range parameter and the Distortion output. [. . . ] (ART) will, without charge, repair or replace, at its option, defective product or component parts upon prepaid delivery to the factory service department or authorized service center, accompanied by proof of purchase date in the form of a valid sales receipt. EXCLUSIONS: This warranty does not apply in the event of misuse or abuse of the product or as a result of unauthorized alterations or repairs. This warranty is void if the serial number is altered, defaced, or removed. ART reserves the right to make changes in design or make additions to or improvements upon this product without any obligation to install the same on products previously manufactured. [. . . ]