User manual AT&T 1715

[. . . ] If a caller leaves a very long message, part of it might be lost when the system disconnects the call after 3 minutes. · If the caller pauses for more than 7 seconds, the system stops recording and disconnects the call. · If the system's memory fills up during a message, the system stops recording and disconnects the call. Power Failure Recovery If the system is disconnected from AC power it will not operate. Your announcement and messages are retained in memory during a power failure, but you will need to reset the clock. System Does Not Answer After Correct Number Of Rings · If the Toll Saver feature is in operation, the number of rings changes from four INSTALLATION 1 Connect the line cord. [. . . ] If you decide to take the call, lift the handset of any telephone on the same line. The system stops recording and resets to answer calls. Volume Control Use V button to adjust the volume of the system's speaker. Press the bottom arrow to decrease volume. Listening to Your Messages As the system plays back messages, the Message Window displays the number of the message playing. Before playing each message, the system announces the day and time the message was received. After playing the last message, the system announces "End of messages. " Play all messages -- Press and release P. If you have no messages, the system announces "No messages. " Play new messages only -- Hold down P for about 2 seconds, until the system begins playing. If you have no new messages, the system announces "No new messages. " Repeat entire message -- Press and release ?. The system beeps while the button is held down. Answering Calls When the system answers a call, the caller hears the announcement you recorded, followed by a beep. After the beep, the system begins recording your caller's message. If the message is longer than 3 minutes, or if the caller is silent for more than 7 seconds, or if the system runs out of memory, the system beeps once and hangs up. Frequent callers can skip over your announcement by pressing #. Ring Select/Toll Saver Use the RING SELECT switch on the right side of the system to select how many times OPERATION Skip to next message -- Press and release /. Skip part of a message -- Hold down / for a few seconds, then release it to resume playing. Stop message playback -- Press and release S. When Memory is Full The system can record approximately 12 minutes of messages, including your announcement, for up to a total of 99 messages. When memory is full, or 99 messages have been recorded, the Message Window flashes F. When memory is full, the system answers calls after 10 rings, and sounds 2 beeps instead of your announcement. Saving Messages The system saves your messages automatically if you do not delete them. The system can save about 12 minutes of messages, including your announcement, for up to a total of 99 messages. When memory is full, you must delete some or all messages before new messages can be recorded. Remote Access Code You can use many features of this answering system remotely from a touch tone phone. Most features can be accessed only after you enter a Remote Access Code, preset to 500. You can change the Remote Access Code to any 3-digit number from 500-999. 4 When the Message Window displays the desired first digit, press and release c. 6 When the Message Window displays the desired second digit, press and release c. 8 When the Message Window displays the desired third digit, press and release c. [. . . ] 4 Press 5 at any time to exit Room Monitor with Intercom. Ending the Remote Access Call Press *, 9. The system announces "The machine will now hang up, " and disconnects from the line. Changing Remote Access Code 1 Press 9, 9. The system announces "Enter new code. " 2 Enter your new Remote Access Code, any number between 500 and 999. 3 If a valid code is entered, the system announces the new Remote Access Code. [. . . ]