User manual AT&T 7620

[. . . ] After the batteries are charged, pick up the handset and extend the base antenna. Press PHONE: the PHONE light should go on and you should hear a dial tone. Wall Mounting Installation 1. Use the Wall Mounting Template and a pencil to mark the screw positions on the wall. Now slip the mounting sleeves onto the screws, with the larger end of the sleeve toward the screw head. [. . . ] NOTE: The Find feature will turn itself off in approximately 3 minutes if you haven't turned it off before then. Memory This cordless phone can store nine telephone numbers that you can dial just by pressing MEMORY and one of the number buttons. Press any number button from 1 to 9 for the memory location where the number is stored. If you hear a long buzzing tone, or nothing at all, press OFF; then follow the steps above to store the number again. This feature is provided only as a convenience and the manufacturer assumes no responsibility for customer reliance upon the memory feature. Press MEMORY. 3. Press the number button (1-9) you assigned to the number you're calling. Directory Card There is a directory card with an erasable surface located on the base to record names or telephone numbers of the numbers stored in memory locations. To write on the card, remove the plastic cover by inserting a pointed object in the hole and prying the cover up until it pops out. NOTE: The numbers stored in memory might be lost when you change the handset batteries or if the batteries run down completely; if this happens, you'll need to store the numbers again. Replacing a Stored Number You can replace a stored number by storing a new number in its place. Storing a Pause in a Memory Dial Number If this phone is connected to a switchboard, you might have to dial an access number (usually 9) to get an outside line. You can store the access number and a pause in the dialing sequence; the pause allows the switchboard enough time to get an outside dial tone. When storing a memory number (see above), press and hold the number button of the digit that comes just before the pause until a second beep is heard. You can insert a longer pause by continuing to press and hold the number button of the digit that comes before the pause. For example, to store 9, PAUSE, 555-1234 in memory location 3: Press MEMORY. Then press 5551234 MEMORY 3. Answering System Operation from the Base Record an Announcement 1. The recorded announcement will play until the end or until you press STOP. Ring Select/Toll Saver This answering system has three Ring Select choices, 2, 4, and TS (Toll Saver). Set to 2 if you want the system to answer calls after the second ring. Set to 4 if you want the system to answer calls after the fourth ring. Set to TS (toll saver) if you want the system to answer calls after the second ring when you have new messages and after the fourth ring when you do not have new messages. On this setting, when you call from another location for messages, you can hang up after three rings knowing you have no new messages, thus saving on toll charges. Automatic Answering Operation The system is ready to answer calls when it is on and the tape is not full. After playing your announcement and sounding a beep, the system records your caller's message: it stops when the caller hangs up or is silent for more than 7 seconds. [. . . ] To end the call without answering, press and release OFF, or return the handset to the base. Play New Messages Only Press and release 2. Save Messages The system automatically saves messages after playback. Repeat/Rewind Press and release 4 while the system is playing messages. Fast Forward Press and release 6 while the system is playing messages. [. . . ]