User manual AUDIOVOX AOM703

[. . . ] In any installations where the Voyager is used to display television broadcasts or recorded video playback, installation location must adhere to local laws and regulations. If evidence of tampering is detected, the warranty will be considered void. While it will withstand short periods of exposure to moisture, this product does contain sensitive electronic components and exposure to moisture should be limited by the user / installer. This product is not designed for applications where constant exposure to moisture or immersion can be encountered. [. . . ] * Note : The unit will not be turn ON when the hazard light are activated. 4 The power button features dual-illumination (bright and dim). In installations where the unit is not wired for Stand-by operation and power is applied to the unit, the Power Button will dimly glow when the unit is off, allowing the user to easily find the control in low light. Source Input Select Button This control toggles the active display image back and forth between AV1, AV2 or AV3 inputs. Day/Night Mode Button This control toggles the unit between "Day" and "Night" LCD illumination modes. In the "Day" mode, the LCD backlight intensity is at maximum. In "Night" mode, the LCD backlight is dimmed to a preset level that is more suitable for low light operation. Picture Adjustment Menu Button This control accesses an On-Screen-Display (OSD) menu for four LCD picture adjustments (Brightness, Contrast, Color, and Tint). The first depress of the button accesses the "Brightness" adjustment. The Volume +/- controls adjust the level, which is indicated by the bar graph at the bottom of the screen. Each consecutive depress of the Picture button accesses the adjustment screen for each picture adjustment. If no buttons are pressed within 6 seconds or controls other than the Picture and Volume buttons are pressed, the unit will exit the Picture Adjustment mode. Volume +/- Buttons This 2-button set of controls adjusts the output volume of the built-in audio speaker when the audio function is enabled *(see typical system connection diagram). Volume level is indicated by the OSD bar graph at the bottom of the screen. These buttons also serve as adjustment controls while in the Picture Adjustment Menu mode (see above section for details). *Note: The AOM703 requires +12V to be applied to the "Audio Enable" trigger input in order to activate the built-in speaker. If no audio output is heard from the speaker regardless of the volume level adjustment, check this connection. S S ­ + 5 INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION: Before drilling, be sure that no cable or wiring is on the other side. Clamp all wires securely to reduce the possibility of them being damaged during installation and use. Keep all cables away from hot or moving parts, and electrically noisy components. Wiring Definitions: ¡ Power connection: Pin 1 ACC +12V (Red) Pin 2 Standby Reverse Trigger (Blue wire) Pin 3 Ground (Black wire) Pin 4 Audio Trigger (White wire) Pin 5 Standby Left Trigger (Brown wire) Pin 6 Standby Right Trigger (Green wire) Connection for camera or camera extension cable Connection for camera or camera extension cable Connection for camera or camera extension cable 13-pin DIN cable connection: junction box to monitor. ¡ ¡ ¡ ¡ Camera A input: Camera B input: Camera C input: LCD panel: Procedure: 1. A ¾" (19mm) hole should be drilled for passing cables through vehicle walls, barriers, etc. [. . . ] If the junction box is mounted further from the monitor, use the 5' intermediate cable included with the AOM703 to connect the monitor to the junction box. If more cable length is needed, additional 5' lengths of the intermediate cable can be purchased. (See the accessory list at the back of this manual for part number details. ) 7. Plug camera extension cable (available separately) into AV1, AV2 or AV3 input connector on the junction box. [. . . ]