User manual BARRACUDA SPAM VIRUS FIREWALL OUTBOUND 3.5.X QUICK START GUIDE

[. . . ] It is common for the Barracuda Spam & Virus Firewall to be installed in the DMZ area of your network or behind a traditional firewall. Once configured, any outgoing message that contains a virus or scored above the quarantine level is automatically blocked and placed in the Quarantine Box. Getting Started This guide provides you with setup instructions for the Barracuda Spam & Virus Firewall v 3. 5. x and below. [. . . ] To begin the configuration: Barracuda Spam & Virus Firewall Configuration Use a computer with a Web browser that is connected to the same network as the Barracuda and follow these steps: 1. In your Web browser's address bar, enter http:// followed by the Barracuda's IP address, followed by the default Web Interface HTTP Port (:8000). For example, if you configured the Barracuda with an IP address of 192. 168. 200. 200, you would type: http://192. 168. 200. 200:8000 2. Log in to the Barracuda Spam & Virus Firewall Web interface as the administrator, Use Username: admin Password: admin 3. Go to the Basic IP Configuration page and perform the following: Verify that the IP Address, Subnet Mask, and Default Gateway are correct. Verify that the Primary and Secondary DNS Server are correct Enter Default Hostname and Default Domain. For example, enter barracuda as the Default Hostname and <yourdomainname>. com as the Default Domain. Barracuda Spam & Virus Firewall Outbound v 3. x - Quick Start Guide Enter outbound. mode under Allowed Email Recipient Domain(s). Click any one of the Save Changes buttons to save all of the information. To avoid damaging the Barracuda, do not power OFF during an update or download. On the AdvancedFirmware Update page, click the Apply Now button to apply the firmware. After applying the firmware, Barracuda Networks recommends logging in to the Web interface again and reading the Release Notes to learn about enhancements and new features. It is also good practice to verify settings, as new features may have been included with the firmware update. Change the Administrator Password To avoid unauthorized use, we recommend you change the default administrator password to a more secure password. You cannot change the password for the Administrative Console, but this is only accessible via the keyboard which you can disconnect at any time. Product Activation Verify that the Energize Updates feature is activated on your Barracuda by going to the BasicStatus page. Under Subscription Status, make sure the Energize Updates subscription is Current. If the Energize Updates is Not Activated, click the corresponding activation link to go to the Barracuda Networks Product Activation page and complete activation of your subscriptions. Convert to Outbound Outbound ensures all email leaving your network is virus-free and legitimate. [. . . ] This will relay all emails to the Barracuda Spam & Virus Firewall Outbound. Be sure to check out the Barracuda Networks Support Forum at: http://forum. barracuda. com for Frequently Asked Questions (FAQs) and other helpful tips for setting up and using your Barracuda Spam & Virus Firewall. For additional documentation including an Administrator's Guide, visit http://www. barracuda. com/documentation. Contact and Copyright Information Barracuda Networks, Inc. Winchester Blvd. , Campbell, CA 95008 USA phone: 408. 342. 5400 fax: 408. 342. 1061 www. barracuda. com Copyright 2005-2010 Barracuda Networks, Inc. [. . . ]