User manual BAUKNECHT GC3SHAXVS INSTALLATION

[. . . ] You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Keep cardboard shipping piece or plywood under refrigerator until it is installed in the operating position. [. . . ] Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. IMPORTANT: If this product is connected to a GFCI (Ground Fault Circuit Interrupter) protected outlet, nuisance tripping of the power supply may occur, resulting in loss of cooling. If nuisance tripping has occurred, and if the condition of the food appears poor, dispose of it. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting. Install copper tubing only in areas where the household temperatures will remain above freezing. A cold water supply with water pressure of between 30 and 120 psi (207 - 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber. IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 - 827 kPa). If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 - 414 kPa). If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 - 414 kPa): s Check to see whether the sediment filter in the reverse osmosis system is blocked. Before purchasing, make sure a saddle-type valve complies with your local plumbing codes. Allow the storage tank on the reverse osmosis system to refill after heavy usage. If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. If you have questions about your water pressure, call a licensed, qualified plumber. Excessive Weight Hazard Use two or more people to move and install refrigerator. When moving the refrigerator for cleaning or service, be sure to protect the floor. Do not wiggle or "walk" the refrigerator when trying to move it, as floor damage could occur. After you remove all of the package materials, clean the inside of your refrigerator before using it. All four leveling legs must contact the floor to support and stabilize the full weight of the refrigerator. Important information to know about glass shelves and covers: Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. [. . . ] Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Use a sturdy container to depress the water dispenser bar until the water begins to flow. Cleaning the system will take approximately 3 minutes and will help clear air from the line. [. . . ]