User manual BAUKNECHT RMC275 PVS INSTALLATION INSTRUCTION

[. . . ] Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a total weight (microwave and built-in oven) of 238 lbs (108 kg). IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. [. . . ] Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Excessive Weight Hazard Use two or more people to move and install oven. To avoid floor damage, set the oven onto cardboard prior to installation. NOTE: Screws for attaching side trims (after oven is installed in cabinet) are in a screw bag inside the package containing literature. Locate the oven door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. Failure to follow these instructions can result in death, fire, or electrical shock. This oven is manufactured with a neutral (white) power supply wire and a cabinet-connected green (or bare) ground wire twisted together. Feed the flexible conduit from the oven through the opening in the cabinet. Connect the green (or bare) ground wire (H) from the oven cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector. IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. Route the flexible conduit from the oven to the junction box through a UL listed or CSA approved conduit connector. See "Electrical Connection Options Chart" to complete installation for your type of electrical connection. Green (or bare) ground wire (from oven) IMPORTANT: Use the 4-wire cable from home power supply in the U. Where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada. Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL listed wire connector. Excessive Weight Hazard Use two or more people to move and install oven. NOTE: Push against seal area of oven front frame when pushing oven into cabinet. Untwist white wire from green (or bare) ground wire coming from the oven. [. . . ] With one # 8­18 x ³/" screw (C) for each side of the vent, fasten vent securely to the oven. Make sure the oven door is closed and the "ON" light is showing in the display area. If you do not feel heat or an "F" appears in the display, turn off the oven and contact a qualified technician. [. . . ]