User manual BAZOO 23250 QUICK INSTALLATION GUIDE

[. . . ] Basic operation of headset Function Command Power on Press and hold the multifunction key for 3-5 seconds until the LED blinks blue Power off Press and hold the multifunction key for 2-3 seconds until the LED blinks red Pairing mode Press and hold the multifunction key for 5-7 seconds until the LED blinks red and blue Multifunction LED display Four blue blinks Note: to save energy, the headset automatically switches to standby mode if not connected to another device within 5 minutes. connecting the headset to a Bluetooth transmitter (mobile phone , USB dongle , etc. Basic procedure is as follows: Place the Avalon BT near the device to be connected (less than 1 meter), and ensure it that pairing mode (see above) is activated. [. . . ] " You may be required to enter a password or PIN code in order to connect. Once the connection is successfully established, you will see "AVALONBT" in the device list of your external component. Note: if connection is unsuccessful, switch off the headset and repeat steps. After successful connection, the Avalon BT and the most recently connected device are "acquainted, " so that the pairing process must not be repeated. If you would like to connect the headset with a different device, power off or deactivate Bluetooth for the previously connected device. Connecting the headset with two devices (multipoint) The Avalon BT may be simultaneously connected with two different devices (mobile phone and PC). Basic connection procedures are as follows: First connect the headset with the computer's Bluetooth transmitter as previously described. Thereafter connect the headset with your mobile phone as described above. A: Make sure the headset power is on and connected with the Bluetooth transmitter. a: Check the headset volume level and if applicable the Bluetooth transmitter volume level. A: Make sure the headset and Bluetooth transmitter are in range of each other. F: Why can't I start/pause or select tracks with the headset during playback?A: Remote control function is supported only by devices with an AVRCP profile. 10 m upp till 9 timmar upp till 240 timmar DC + 5, 0V ±0, 25VA 1, 5 ­ 2 timmar 120g 4) Automatisk anslutning till den sist anslutna apparaten 5) Anslutning till flera apparater samtidigt (multipoint) Anmärkning: Även om den externa apparaten stöder de angivna profilerna kan speciella funktioner eventuellt avvika från denna beskrivning. Då måste du ladda upp headsetsystemet igenAnslut USB-laddningskabeln till headsetet och till en ledig USB-anslutning på din dator. Anmärkning: headsetet kopplar automatiskt till standby för att spara ström ifall det inte ansluts till en annan apparat inom 5 minuter. [. . . ] Då måste du ladda upp headsetsystemet igenAnslut USB-laddningskabeln till headsetet och till en ledig USB-anslutning på din dator. Anmärkning: headsetet kopplar automatiskt till standby för att spara ström ifall det inte ansluts till en annan apparat inom 5 minuter. Anslutning av headsetsystemet till en bluetooth-sändare (mobiltelefon, USB-dongle eller liknande) Se till att din mobiltelefon, PDA eller liknande apparat stödjer bluetooth-funktionen och att bluetoothsystemet är tillkopplat. [. . . ]