User manual BAZOO 25720 QUICK INSTALLATION GUIDE

[. . . ] Replacing fuse covers: When replacing a faulty fuse, a 13amp ASTA approved fuse to BS 1362 should always be used and the fuse cover re-fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained. Replacement fuse covers: If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Positioning and connection Positioning 1. The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. [. . . ] Turn the FREEZER OPERATION knob to an average value and press the SUPER FREEZE button (rapid freezing): the SUPER FREEZE indicator light will illuminate. Once the refrigerator has reached the optimal temperature, the indicator light goes out and you can begin food storage. After a few hours you will be able to put food in the refrigerator. Using the refrigerator to its full potential • Use the REFRIGERATOR OPERATION knob to adjust the temperature (see Description). • Press the SUPER COOL button (rapid cooling) to lower the temperature quickly. For example, when you place a large number of new food items inside a fridge the internal temperature will rise slightly. The function quickly cools the groceries by temporarily reducing the temperature until it reaches the ideal level. • Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). They will increase humidity in the refrigerator and cause condensation to form. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Height can be adjusted without complete removal of the shelf. 1 2 Chiller system No Frost It is recognisable by aeration cells located on the back walls of the compartments. The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. • The removable accessories may be soaked in warm water and soap or dishwashing liquid. • The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. • When unplugging the appliance always pull the plug from the mains socket, do not pull on the cable. • Before cleaning and maintenance, always switch off the appliance and disconnect it from the electrical supply. It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. • In the case of a malfunction, under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or further malfunctioning of the appliance. • Do not use devices or tools other than the special scraper provided inside the compartments. [. . . ] b/c) Heating is excessive + buzzer Heating danger In the first case the freezer will maintain a temperature of about 0°C so that the food does not re-freeze. In the second case, however, the temperature will remain at approximately -18°C. To restore normal operation bring the FREEZER OPERATION knob setting to (off) and turn the appliance on again. + buzzer The green POWER indicator light flashes. • The appliance is not operating correctly. Contact the Technical Assistance Centre. The refrigerator and the freezer do not • The doors do not close properly or the seals are damaged. [. . . ]