User manual BEGLEC FALCON VERSION 1.0

[. . . ] lamp shuts off automatically in blackout mode for extended lamp life. Optional CA-8 controller available with 3 different functions: o STANDBY: switch blackout function on/off o FUNCTION: "Fast mode" different strobe modes. To protect the environment, please try to recycle the packing material as much as possible. [. . . ] This input receives instructions from a DMX-controller or from another Falcon light effect when used in master/slave mode. DMX OUTPUT: 3pin female XLR-connector used to connect the Falcon with the next unit in the DMX chain or with another Falcon when used in master/slave mode. Use the small knob on top of the Falcon to adjust the focus of the gobos: · Loosen the knob (see photo) a little until you can move it forward and backward. Standalone 1unit: Just connect the unit to the mains and put on some music. Two or more units in master/slave setup: Connect 2 or more units together using good quality balanced XLR microphone cables (like for example JB Systems code 7-0063). The unit that has no cable connected to its input will react as master; the others are the slave units. You don't have to worry about the settings of the DMX DIP-switches!It is only possible to inverse the behavior of a slave unit by changing the position of DIP-switch n°10. Connect the optional CA-8 controller for more control: The CA-8 controller can only be used in standalone or master/slave mode. Blackout, the lamp will be switched off automatically to extend its lifetime. press the button to switch the led on; now the Falcon is in SLOW mode. The beam movements are sound activated but the gobo/color wheel is static and can be controlled with the FUNCTION-button. FUNCTION BUTTON: (strobe/next) Push the FUNCTION button while the Falcon is in FAST mode (MODE led is off) the units will strobe in 3 different ways: · Two-light strobe in white color Every time you push the FUNCTION-button while the Falcon is in SLOW mode (MODE led is on) the colors/gobos of the connected units change. Controlled by universal DMX-controller: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected light effects with a good quality XLR M/F balanced cable (ex. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. [. . . ] Channel 1 Shutter 255 Fastest speed Channel 2 Gobos/Colors 255 Fastest speed Channel 4 Zoom 255 Fastest speed Zoom in/out (continue) 160 Slowest speed 159 Zoom out max. Gobo Shaking 136 Slowest speed 135 Fastest speed Stromversorgung: Sicherung: DMX-Verbinder: Leuchtmittel: Maße: Gewicht: AC 230V ­ 250V, 50Hz 250V 5A fast blow (20mm glass) 3pin XLR male / female ELC 250W ­ 24V 34 x 32 x 22cm 9kg We declare that our products (lighting equipment) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. We declare that our products (Remote Controller) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. [. . . ]