User manual BEGLEC LP-8115 V1.0

[. . . ] To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. This LP-8115/LP-8140 can only be used together with the JB SYSTEMS LED MANAGER !DON'T CONNECT DIRECTLY TO 230Vac or any ordinary 24Vdc power supply ! [. . . ] Using the included hanging bracket to fix the LP-8115/LP-8140 with a mounting hook 2. Using the included hanging bracket: The hanging bracket has 2 knobs and a mounting hole to fix a small mounting hook. Before installing this unit, please take note of following information: Make sure the area below the installation place is free from unwanted persons while installing The device should be well fixed, free-swinging mounting is dangerous and may not be considered!To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. If a foreign object enters the unit, immediately disconnect the mains power. Make sure the area below the installation place is free from unwanted persons during installation and servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Installing the LP-8115/LP-8140 in a mounting panel USING THE SPRING CLIPS: IMPORTANT NOTE: Before you start installing the unit, be sure to remove the hanging bracket first ! Before installing this unit, please take note of following information: The diameter of the hole cutout has to be 125mm x 125mm The thickness of the mounting panel (ceiling) can be up to 15mm Make sure the area below the installation place is free from unwanted persons while installing How to install the unit: Install the Spring Clips on both sides of the enclosure. Make sure you make the electrical connections before you install the unit in the mounting panel! slide the armature in the 125mm x 125mm hole of the mounting panel (ceiling). Installing the LP-8115/LP-8140 in a mounting panel USING 4 SCREWS: You will have difficulties using the spring clips when the mounting panel is thicker than 15mm. in that case you can mount the armature as follows: Make a hole as shown on the drawing. [. . . ] Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. The cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. [. . . ]