User manual BEGLEC SPACE 3 LASER VERSION 2.0

[. . . ] Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. [. . . ] CONTROL PANEL: Used to control the different functions of the laser, see further to learn how to operate the unit. REMOTE CONTROLLER INPUT: Input for the CA-8 remote hand controller, see further for more information on this issue. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. We suggest to take off the plastic cover from time to time to clean the dust filter inside. Don't operate the unit without the dust filter installed: dust will enter the enclosure and disturb the operation of the laser. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure; make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect the supplied mains cable here. Use the keys to make sure only a skilled operator is able to switch the laser on. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ] 5) DMX512 MODE: The laser can be controlled by any standard DMX-controller in 2 different DMX-modes: 1 CHANNEL MODE: for extremely easy setup and use!Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. [. . . ]