User manual BELSON BP2003

[. . . ] 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 14) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 15) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. [. . . ] If opening the door soon after the end of the programme, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. ARISTON DISHWASHER - Instructions for installation and use 15 D ISHWASHER Only use specific dishwasher detergents. The detergent should be poured into the two containers C and D up to the rim. If you prefer to use the detergent in tablet form, then place one inside the container “D” and close the lid. Detergent and rinse aid Useful tips • Use the right amount of detergent: if you use too much, you will not get cleaner dishes, but just more environmental pollution. Check whether there is any detergent residue on the edges of the dispenser. • Keep your dishwasher detergent and rinse aid in a cool, dry place and away from children. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. In or out depending on how high In this case, the wash cycle time you want it and to level it so that it will be about 15 minutes shorter is horizontal. Make sure that it is and the wash will be slightly less not inclined more than 2 degrees. If the appliance is level, it will help The connection must be made to ensure its correct operation. Hot water supply following the same procedures as those indicated Adjusting the back Feet for the cold water connection. Insert the appliance into the cutout A and then adjust the height using the Anti-flooding protection screws located on the front bottom Your dishwasher is provided with a part of the machine. Use a special system which blocks the screwdriver to turn the screws in water supply in the event of leaks the clockwise or anti-clockwise inside the appliance. It is further direction to increase or decrease equipped with a water inlet hose the height respectively. That can withstand extremely high pressures and that turns bright red Cold water connection. In It is vital that you check it on a On some models, a transparent the event of replacements, use regular basis: if you see it has turned condensation-proof adhesive tape original spare parts only. It should be stuck onto the lower hose to a 3/4 gas threaded Call for an authorised technical side of your wooden worktop to protect it from the formation of connection, taking care to screw it engineer to come and replace it. If the water When not provided, this tape can hoses are new or have been out of Drain hose connection. [. . . ] The food particles are removed from the wash water, allowing it to be recirculated during the cycle, filtered perfectly. For this reason, it is a good idea to remove the larger food particles trapped inside the cup “C” and the semi-circular filter A after each wash; pull the cup handle upwards to remove them. The entire filter assembly should be cleaned thoroughly once a month: cup C + semi-circular filter A + cylindrical filter B. Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. [. . . ]