User manual BELSON C-28-B-6 TO C-28-B-8

[. . . ] For optimum styling performance, let the brush continue to heat for about 3 minutes before using. Use only if hair is very coarse and highly resistant, but in good condition. [. . . ] Due to the extreme heat capabilities of this brush iron, the barrel will be very hot in the HI (17-20) settings, so extra care should be taken when using. For shorter hair, place a thin plastic comb between scalp and barrel to avoid touching scalp. Place fingers of free hand on safety tip when more control is needed for curling. Test small section of hair to determine correct heat setting for the type of hair being styled. SPECIAL FEATURE: This brush iron features solid-state electronic circuitry with a heat sensor that detects temperature loss and quickly boosts the power to bring the heat level back to optimum styling temperature. This allows for styling in half the time it takes with an ordinary iron. TO USE: For a complete styling, hair should be clean, dry and free from dirt, hair spray, creams, etc. Then, select a temperature according to the type and texture of hair to be styled. HOW TO GET PROFESSIONAL RESULTS WITH THIS CURLING BRUSH This unique curling brush has been designed with multiple temperatures, providing very high heat in the HI (17-20) settings for curling very coarse, thick, hard-to-curl hair, and very low heat in the LO (1-4) settings for This appliance requires little maintenance and contains no user serviceable parts. Do not allow water or any other liquid to go into handle of the brush iron. TO STORE: Unplug appliance and let it cool; store in its box or in a clean, dry place. Never wrap the cord around unit; this could cause the cord to wear prematurely and break. Do not put any stress on cord where it enters the handle, as it could cause cord to fray and possibly break. Never hang unit up by the power cord -- use the hanging ring provided. [. . . ] As a safety feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug and try again. [. . . ]