User manual BELSON C23-WS

[. . . ] For optimum styling performance, let the iron continue to heat for about 2-3 minutes before using. Use only if hair is very coarse and highly resistant, but in good condition. MED/HI (16-20): Use heat settings in this range for dense, hard-to-curl hair in good condition. MEDIUM (13-15): Use heat settings in this range for thick, wavy hair in good condition. [. . . ] MEDIUM (13-15): Use heat settings in this range for thick, wavy hair in good condition. LO/MED (7-12): Use heat settings in this range for easy-to-curl, normal hair. LO (1-6): Use LO heat setting for very fine, fragile, light-colored hair. STYLING: Start by sectioning hair into strands of not more than 1 inch deep and 2 inches wide. Keep the hair strand smooth by brushing or combing through the section while holding the ends taut with the other hand. Taking one section at a time, place the ends of hair over the barrel with the clamp open. Then close the clamp, making sure that the ends extend just a tiny bit beyond the clamp. Grasp the safety tip with the other hand, and it will be easy to roll hair. Keep the section of hair taut as you wind it around the hot barrel by turning the handle with one hand and the safety tip with the other. Wind the curl toward the scalp as far as you wish to go without touching scalp with the hot barrel. S Close supervision is necessary when this appliance is used by, on, or near children or invalids. S Use this appliance only for its intended use as described in this manual. S Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged in any manner or dropped into water. S Do not use outdoors or operate where aerosol (spray) products are being used. To avoid burn hazard, do not let eyes and bare skin touch heated surfaces. S Do not place the heated unit directly on any surface while it is hot or still plugged in. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug and try again. Before each use, inspect the line cord for cuts and/or abrasion marks. [. . . ] As a safety feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug and try again. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates that the appliance should be serviced and the line cord replaced. [. . . ]