User manual BOMANN CB 2001

[. . . ] Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. the appliance is designed exclusively for private use and for the envisaged purpose. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. [. . . ] The further you turn the switch away from the OFF position in an anticlockwise direction, the greater the quantity of steam that is expelled. ⷠAfter the heating process turn the hot water/steam switch back to the OFF position. In order to be able to make coffee again you must turn the machine back to the normal mode. Button Start the percolation process with the when you have reached the desired filling quantity. If you would like to program presets you must change to the programming mode. You can set the following presets, filling quantity, pre-injection, percolation time and percolation temperature. There are two ways to select the following menu item and change the presets: One-Time Preset: If you want to change the presets only for the next percolation process, but do not wish to store them, please proceed as follows: · Keep the MENU/OK/ MEMORY button pressed down for five seconds. / BACK button once you Note: By pressing the reach the programming mode of the presets for the "large cup" (the symbols "large cup" and "M" flash in the display). Button Stop the percolation process with the when the desired filling quantity has been reached. The preset filling quantity is 100 ml when the saved or the one-time selected setting is used. Coffee Quantity You can make your coffee with a small, normal or large quantity of coffee. the "normal" setting is shown in the display by 2 arrowheads in the middle. Please ask your local drinking water supplier about the degree of hardness of the water in your area. In the soft water setting the arrowheads are on the left, while in the hard water setting they are on the right. Clean the exterior of the machine and the accessories with a damp soft cloth. Cleaning the Coffee Grinding Mechanism Never fill the coffee bean container (2) with water. Hot Water/Steam Nozzle The steam pipe and the Maxi cappuccino device should be cleaned after every use. In order to ensure that the Maxi cappuccino device is cleaned thoroughly it can be removed (pull downwards out of the steam pipe). Cleaning the Coffee Spout The coffee spout (13) can be removed for cleaning. Total Number of Prepared Cups You can call up the total number of prepared cups. Press the MENU/OK/MEMORY button until two coffee cup symbols flash simultaneously in the display. Each of the arrowhead pairs on the edge of the display stands for 500 prepared cups. [. . . ] You have pressed the hot water/steam Turn the hot water/ switch (9) while steam switch back the machine is to the OFF position. Loss of electronic data in the machine, but this does not cause any fault. Symbol lights up while "M" flashes The brew group is not correctly inserted. The drip collector or coffee grounds collector is symbol lights up not correctly installed. [. . . ]