User manual BOMANN VSE 228

[. . . ] The appliance and if possible the mains lead have to be checked regularly for signs of damage. For safety reasons, alterations or modifications of the appliance are prohibited. In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc. This unit is intended to be used in household and similar applications such as - staff kitchen areas in shops, offices and other working environments; - farm houses and by clients in hotels, motels and other residential type environments; - bed and breakfast type environments; - catering and similar non-retail applications. [. . . ] Reverse the door opening If required, the door opening can be moved from the right (supplied condition) to the left side. WARNING: When replacing the door stop, the appliance must be disconnected from the power supply. You possibly need: screw wrench, Phillips screw- Open the door a little and take it carefully off the lower door hinge. Insert the appliance door on the lower hinge pin and fix the door to the property position. Attach the upper limit plate after you have unscrewed the hinge pin and used it on the other side of the plate. Insert the hinge pin in the hole of the appliance door and tight the plate. Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the door is ensured. The ventilation openings in the furniture base and building must be min. Install the power cord so that the appliance can be easily connected after installation. Slide the appliance into the build-in opening until the stop plate (A) abuts the furniture. Press the rubber seal between the appliance and built-in furniture firmly (on the side without hinge). Push the appliance side, which is located opposite the hinges, against the built-in furniture. Arrange the appliance for a secure, vertical position, fix it with the supplied screws and put the protective cap (B) on. In consideration of the shown distances, hold the guide (a) at the top and bottom inside of the furniture door; mark the positions of the drill holes. Remove the bracket and drill Ø 2 mm holes with about 8 mm distance to the outer door edge. If an aligning of the furniture door is necessary, use the slot spacing. Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the door is ensured. See also the Setting [0] means that the appliance is in the off state. Turn the temperature control clockwise, starting from this setting; the appliance will turn on automatically. The power levels [1­7] regulates the different values of the internal temperature. Note that the temperature will change depending on the ambient temperature, frequency of door opening and the amount of food in the appliance. During initial operation, turn the temperature control to the highest setting first, until the appliance has reached the desired operating temperature. [. . . ] - Are the ventilation openings clear of ob- - Was the appliance door open for an ex- tended period?- Was large quantity of food placed in the appliance within the last 24 hours?- Does the appliance not stand vertical or - Is the water discharge channel / opening Solution - Insert the plug properly in the contact socket. Meaning of the "Dustbin" Symbol Protect our environment; do not dispose of electrical equipment in the domestic waste. [. . . ]