User manual BOSCH GWS 24-180 BV

[. . . ] In addition, the general safety instructions in the enclosed booklet must be followed. If the mains cable is damaged or cut through while working, do not touch the cable but immediately pull the mains plug. Hold tools by insulated gripping surfaces when performing an operation where the cutting tool may Do not drill, fasten or cut into blind areas where electric, gas or water lines may exist. Use appropriate detectors to determine if these lines are hidden in the work area or call the local utility company for assistance. [. . . ] Breaking into a water pipe will cause property damage or may cause an electric shock. Check for correct mains voltage: The voltage of the power Source must agree with the voltage spe-cified on the nameplate of the machine. Continuous use Switching on: Press On/Off switch 4 and retain with locking button 5. TWO-STEP SWITCH (GSB 13-2) Two rotational speed ranges can be selected with On/Off switch 4. The machine switches from the first to the second rotational speed step after a perceptible pressure point has been exceeded: - Rotational speed step I: 2500 min -1 - Rotational speed step II: 3000 min -1 The On/Off switch can be locked in either of the rotational speed steps by means of locking button 5. STEPLESS SPEED CONTROL (GSB 13 RE) The machine runs with variable speed between 0 and maximum depending on the pressure applied to the On/Off switch 4. Light pressure results in a low rotational speed thus allowing smooth, controlled starts. Using the rotational direction switch 3, the direction of rotation of the machine can be changed (by actuating the On/Off switch 4, the rotational direction switch 3 can be locked). ) Press the rotational direction switch through to the left stop (for drilling, impact drilling, driving screws, etc. Distractions can cause you to lose control G) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. unmodified plugs and matching outlets will reduce risk of electric shock B) Avoid body contact with earthed or grounded surfaces such as pipes, radiators and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. E) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. B) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. C) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. [. . . ] C) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. D) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. [. . . ]