User manual BOSCH PBH 200 RE

[. . . ] In addition, the general safety notes in the enclosed booklet must be observed. If the cable is damaged while working, do not touch the damaged cable but pull the mains plug. For machines used outdoors, connect to the mains using a fault current (FI) protection switch. Use suitable detectors to find hidden utility lines or call the local utility company for assistance. [. . . ] PBH 160 RE/180 RE/1800 RE/200 RE To work with tools without SDS-plus (e. , drills with cylindrical shafts), a drill chuck 17 with a SDS-plus chuck shaft 18 (optional accessory) must be inserted into the tool holder (Fig. Insert the dust-free, assembled chuck into the tool holder 3 with twisting until it latches (Fig. H ) Turn the collar of the ring gear exchangeable drill chuck until the tool holder is opened wide enough. Insert the tool and clamp with the drill chuck key 21 uniformly in all three holes. I ) To remove a tool from the ring gear exchangeable drill chuck, turn the collar in the direction of the arrow until the tool can be removed. Take care that the dust protection cap 4 is not damaged when changing tools. Insert the dust-free tool into the tool holder 3 with twisting until it latches. The voltage of the power source must agree with the value given on the nameplate of the machine. To switch off the machine, release the on/off switch 8 or press and then release it. K ) For safety reasons, the machine should be used only with the auxiliary handle 14. By rotating the auxiliary handle 14 to a comfortable position, a fatigue-free and therefore safe working position can be achieved. As a result of the forces that occur, always hold the machine firmly with both hands and provide for a sure footing. Read the value from the scale 22, subtract the desired drilling depth t and set the resulting value on the depth stop scale. N ) With the speed regulator 9, the required highest speed can be pre-set. As a result of this limitation, the on/off switch can be pressed only to the pre-set highest speed. The speed must be selected according to the operating mode, the material to be worked and the diameter of the drill. The operation of the gearbox for each application is set with the mode selection switch 11: Drilling Hammer Drilling The operating mode selector switch may be actuated only at a standstill. The following table shows how the operating mode selector switch 11, the right/left rotation switch 10 as well as the speed regulator 9 are to be set for the various operating modes (See fold-out page for figures): Operating Mode Type PBH 160 RE/ 180 RE/ 1800 RE/ 200 RE Hammer drilling in concrete or stone Drilling in steel or wood Screw driving Right rotation Left rotation Fig. Dust Vacuuming/Vacuuming Attachment s Take protective measures when dust is produced while working that is detrimental to health, combustible or explosive. [. . . ] Important: If the plug on the cable of this machine must be replaced, dispose of the old plug to prevent misuse. If the machine should fail despite the care taken in manufacture and testing, repair should be carried out by an authorised customer services agent for Bosch power-tools. For all inquiries and replacement parts ordering, always include the 10-place article number on the nameplate of the machine. We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 89/336/EEC, 98/37/EC. [. . . ]