User manual BOSCH PSR 14 4 LI-2

[. . . ] Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. D) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. [. . . ] A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. C) When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. D) Under abusive conditions, liquid may be ejected from the battery; avoid contact. 6) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. High reaction torque can briefly occur while driving in and loosening screws. Use appropriate detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Penetrating a water line causes property damage or may cause an electric shock. The tool insert jams when: -- the power tool is subject to overload or -- it becomes wedged in the workpiece. Hold the machine only by the insulated gripping surfaces, when performing an operation where the cutting tool may run into hidden wiring. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Remove the Allen key from the keyless chuck and completely unscrew the keyless chuck. mounting the Drill Chuck (see figure E) The keyless chuck is mounted in reverse order. Note: After mounting the keyless chuck, screw the securing screw 14 in again. A battery that is new or has not been used for a longer period does not develop its full capacity until after approx. The battery is equipped with a NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. A significantly reduced working period after charging indicates that the battery is used and must be replaced. Inserting the Battery Use only original Bosch O-pack batteries with the voltage given on the type plate of your machine. set the rotational direction switch 11 to the centre position in order to avoid unintentional starting. Insert the charged battery 9 into the handle so that it can be felt to engage and faces flush against the handle. Reversing the Rotational Direction (see figure B) The rotational direction switch 11 is used to reverse the rotational direction of the machine. Right Rotation: For drilling and driving in screws, push the rotational direction switch 11 left to the stop. [. . . ] If the gear selector 3 cannot be pushed through to the stop, lightly turn the drill chuck with drill. switching On and Off To start the machine , press the On/Off switch 12 and keep it depressed. The power light 10 lights up when the On/Off switch 12 is slightly depressed, and enables illumination of the screwing location in unfavourable light conditions. Adjusting the Speed The speed of the switched on power tool can be variably adjusted, depending on how far the On/Off switch 12 is pressed. [. . . ]