User manual BOSCH PSR 14.4-2

[. . . ] 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Take protective measures when dust can develop during working that is harmful to one's health, combustible or explosive. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Ensure the On/Off switch is in the off position before inserting battery pack. Carrying the power tool with your finger on the On/Off switch or inserting the battery pack into power tools that have the switch on invites accidents. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for driving in and loosening screws as well as for drilling in wood, metal, ceramic and plastic. We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 89/336/EEC, 98/37/EC. Cordless Screwdriver Article number Rated voltage No-load speed ­ 1st gear ­ 2nd gear Max. Typically the A-weighted sound pressure level of the machine is lower than des 70 dB(A). Overall vibrational value (vector sum of three directions) determined according to EN 60745: Drilling in metal: Vibrational emission value ah =<2. WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to a significant underestimate of exposure when the tool is used regularly in such a way. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. ) as well as during transport and storage, set the rotational direction switch to the centre position. The keyless chuck 1 is secured with a securing screw 14 against unintentional loosening from the drill spindle. [. . . ] In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. Exploded views and information on spare parts can be found under: www. Ni-MH: Nickel metal hydride Do not dispose of battery packs/batteries into household waste, fire or water. battery packs/batteries should be collected , recycled or disposed of in an environmental-friendly manner. [. . . ]