User manual BRANDT AD546BE1

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BRANDT AD546BE1. We hope that this BRANDT AD546BE1 user guide will be useful to you.


BRANDT AD546BE1 : Download the complete user guide (704 Ko)

Manual abstract: user guide BRANDT AD546BE1

Detailed instructions for use are in the User's Guide.

[. . . ] qxd 21/04/05 13:49 Page 11 T he controls on your hood 3-speed model Fig. 1 GB Light off Light on Motor off Slow speed Medium speed Fast speed In the case of a kitchen heated by a device connected to a chimney (for example a stove) the "recycling" version of the hood should be installed. Suitable ventilation should be ensured for the room when the suction hood is used at the same time as appliances using gas or another combustible fuel. [. . . ] If your flue is below 125 mm in diameter, you must obligatorily use the "recycling" mode. In this case, you should add an active carbon filter which will keep in odours. A ssembling your hood The hood must be installed in conformity with the applicable regulations concerning the ventilation of premises. In particular, the evacuated air must not be channelled into a duct used to evacuate fumes from appliances using gas or other combustible fuels. Disused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. - Attach the adhesive foam joint inside the upper register of the lining (fig. - Draw a vertical line on the wall running from the ceiling to the lower edge of the hood. - Prepare your chimney taking care to place the vents toward the top to ensure that they are visible (fig. - Adjust the length of the telescopic chimney by bringing down the lower part and fitting it into the top of the hood. Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. The power supply to the hood must be turned off either by removing the plug or by using the circuit breaker switch before you remove the metal filters. After cleaning, the metal filters must be refitted in conformity with the instructions. FILTER CARTRIDGE Remove the protective film before using the filter cartridge for the first time. This component plays an important part in ensuring the effectiveness of your hood. Use a commercial household cleaning product then rinse abundantly and dry. This cleaning can be This filter traps odours and must be changed at least once a year depending on your level of use. [. . . ] You should order these filters from your dealer (quoting the reference shown on the ID plate located inside the hood) and note the date the filter was changed. Carried out in your dishwasher in the vertical position (ensure that the cartridge never comes into contact with dirty crockery or silver tableware). never use metal scouring pads , abrasive products or excessively stiff brushes. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BRANDT AD546BE1




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BRANDT AD546BE1 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.