User manual BRAUN KF7170SI

[. . . ] 15 14:20 IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: READ ALL INSTRUCTIONS. The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance by a person responsible for their safety. Always unplug appliance from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts and before cleaning the appliance. [. . . ] €¢ To switch off the coffee maker, press the On/Off button again. Programming the Coffee Maker NOTE: The coffee maker features a 60-second power loss back-up system that remembers all programmed information, including time of day and auto on/off times in the event of a tripped breaker, unit is unplugged, or power failure. €¢ Press the AUTO ON button again to save the desired time. €¢ The pre-set auto on time will disappear after 3 seconds and the time of day will show on the LED control panel. €¢ If during the setting process no button is pressed for 10 seconds, the auto on time currently set will be saved. This function can only be activated if the auto on time and the time of the day have been set. To activate the AUTO ON function: • Press the AUTO ON button (b). The green LED above the button will illuminate and the coffee maker will start to brew at the pre-set auto on time. €¢ When the appliance starts brewing, the green LED BREW will continually flash and the LED AUTO ON turns off. €¢ Press the AUTO ON button (b) again to switch off the function: the green LED light will disappear. NOTE: The AUTO ON function remains activated even when the appliance has been switched off (1). Setting the Time When the coffee maker is first plugged in or when power is restored after an interruption, the LED control panel will start flashing 2:00 AM. €¢ To set the hour, press the CLOCK button (d) for a minimum of 3 seconds. €¢ Press and hold the SET button (e) to scroll through the numbers. €¢ Press and hold the SET button to scroll through the numbers. €¢ Press the CLOCK button again to save the desired time. €¢ If during the setting process no button is pressed for 10 seconds, the time currently set will be saved. NOTE: When the number count passes 12, the PM light will be displayed on the LCD. Programming and Activating the AUTO OFF Time The auto off time can be set in 5 minute intervals, anywhere from 15 minutes to 5 hours. €¢ Press the AUTO OFF button (c) for a minimum of 3 seconds. €¢ Press and hold the SET button (e) to scroll through the numbers. €¢ Press the AUTO OFF button again to save the desired time. [. . . ] We recommend using the Braun Descaling Solution (can be purchased in stores, through the Braun website, or by calling Customer Service). The entire cleaning cycle including rinsing can take up to 45 minutes to complete. €¢ Remove the charcoal water filter holder (8) including the charcoal water filter (7) and the gold tone permanent filter (5). €¢ Place the empty carafe in its position on the keep warm plate (9). [. . . ]