User manual BREVILLE 800CPXL

[. . . ] ⷠThe use of accessory attachments not recommended by Breville may cause a risk of injury to persons, fire or electric shock. ⷠWhen using this appliance, provide adequate air space above and on all sides for circulation. ⷠIf the appliance is of the grounded type, the extension cord should be a grounded type and its electrical rating must be the same or more wattage as the appliance. ⷠTo protect against fire, electrical shock and injury to persons do not immerse the appliance, motor base, cord or plug in water or any other liquid. [. . . ] Note: The Fruit Dome is keyed, and can only be inserted in one way (this will ensure that it does not rotate through operation). Ensure the Die Cast Citrus Press is correctly assembled with a glass or jug, placed under the Juice Spout before juicing commences. Cut the citrus fruit in half by cutting across the fruit segments, rather than across the tip ends, to ensure more efficient juicing. For the best contact with the Fruit Dome, smooth the outside of the fruit by trimming any knobbly tip ends such as the ends of a lemon or tangelo. Plug the power cord into a 120v power outlet and then switch the On/Off button to ON. Do not lower the Juicing Press Arm too quickly or the motor will hesitate and the Juicing Cone will not spin. This is because the Diecast Series Citrus Press is fitted with a motor that increases in strength as the motor spins. It is therefore better to push down lightly for the first few seconds to allow the motor to start spinning. The motor can then generate the strength necessary to cut through tough pulp. Grasp the Soft Grip Handle and slowly lower the Juicing Press Arm and press down firmly until the Fruit Dome is in contact with the fruit skin. the motor will automatically start and the Juicing Cone will begin to rotate. The juice will be extracted from the fruit and flow through the Juice Spout into the glass. NOTE: The Stainless Steel Filter should be emptied when full with pulp and seeds. The Filter can be emptied during juicing by switching the Citrus Press "OFF" at the On/Off button and carefully removing the Juicing Cone and Filter. Clean and replace Stainless Steel Filter and Juicing Cone before continuing to juice. Do not allow the Stainless Steel Filter to overfill as this may prevent correct operation or damage the unit. The Die Cast Citrus Press juices very quickly so each fruit half will be juiced in a few seconds. Switch the Citrus Press "OFF" at the On/Off button and unplug the unit from the power outlet. 1 Pull the Juicing Press Arm up and backwards, away from the Motor Base, until fully extended. Lift the Juice Collector from the Motor Body with the Stainless Steel Filter and Juicing Cone still in place. Remove the Cone and Filter from the Juice Collector over a sink for easier cleaning. Follow recommended Care and Cleaning guidelines and insert the Dust Cover before storing. [. . . ] ⷠMore juice is obtained from fruit stored at room temperature. Breville®* warrants this Breville® appliance against defects that are due to faulty material or workmanship for a period of one (1) year from the date of original consumer purchase. This warranty does not cover damage from abuse, neglect, use for commercial purposes, or any other use not found in the printed "Instructions for use" booklet. There is no warranty for glass parts, glass containers, filter basket, blades and agitators. [. . . ]