User manual BUFFALO HD-AVU2: DRIVESTATION™ AV

[. . . ] Glowing blue: The remaining capacity is 11% or more Glowing red: The remaining capacity is 10% or less Flashing red: The fan is malfunctioning It will flash while you are recording or playing media. Flashing blue: Playing recorded media or reading saved data Flashing red: Recording media or writing data Power LED This LED shows whether or not the DriveStation is powered on. [. . . ] Even when the power is off, the device is still warm due to the standby current. * A delayed write error may be displayed by some computers when they return from an energy-saving state. If this happens, detach your drive before putting your computer into an energy-saving mode. * If the power/access LED does not turn off when you turn off your computer, unplug the USB cable from the drive. * If you configure multiple partitions on the drive, format each volume before use. If this happens, unplug the USB cable, then plug it again after a few seconds. * If your Windows computer will not boot while this drive is connected, then connect the drive to your computer after rebooting Windows. Also, refer to your computer's manual to change the BIOS setting to boot from an internal hard drive if you want to turn on or off your computer while this unit is connected. * The cooling fan inside the DriveStation operates only if the internal temperature becomes high. * To reduce the risk of receiving or causing the electromagnetic interference, please use the USB cable supplied. * When the drivers for this unit are installed, devices are added to [Device Manager]. If "Do you want to allow the following program to make changes to this computer?If your computer is turned off, then it is always safe to unplug the DriveStation. If your computer is turned on, please follow the procedure below to unplug your DriveStation. [. . . ] [Start] () [Computer] () [Manage] "Do you want to allow the following program to make changes to this computer ?Exe] [Run DriveNavigator] ( DriveNavigator) "Do you want to allow the following program to make changes to this computer ? [. . . ]