User manual CANDY ALISE 084

[. . . ] Lint and fluff must not be allowed to collect on the floor around the outside of the machine. Always allow the dryer to complete the cool down period before removing the laundry. Never install the dryer against curtains and be sure to prevent items from falling or collecting behind the dryer. The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer. [. . . ] Tumble dryers are supplied to operate at a voltage of 230V, 50 Hz single phase. Check that the supply circuit is rated to at least 10A Electricity can be extremely dangerous. The plug should be accessible for disconnection after the appliance has been installed. The wires in the mains lead are coloured in accordance with the following codes: Blue NEUTRAL Brown LIVE Green and Yellow EARTH CE Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments. You may be charged for a service call if a problem with your machine is caused by incorrect installation. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the spares service. Do not plug the machine in and switch it on at the mains until the installation is completed. If there is any doubt about installation, call GIAS Service for advice. VENTILATION Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Check regularly that the air flowing through the dryer is not restricted. Programme Selector ­ Select the required programme Delay Start button ­ Allows the user to delay the start of the drying cycle (see details of Operation on page 10) Start/Pause button ­ Press to commence the selected drying programme Delicates button ­ Press to reduce the heat level for delicate items, the indicator above the button will light up. To change the heat setting the programme must be reset Low Heat ­ Indicator light ON High Heat ­ Indicator light OFF Filter Care indicator ­ lights when the filter needs cleaning Empty Water indicator ­ lights when the water container is full Progress display DRY ­ When the programme is selected the DRY indicator will flash, when the programme starts the DRY indicator will light up. ­ Indicator lights when there is a short time left until completion of the programme. The Candy Sensor Dry machine gives many options for drying the laundry to suit all circumstances. The table on the next page lists the programmes and the function of each programme. For small loads and separate items or pre-dried fabrics with low moisture content, use the timed programmes. Set the programme between 30 and 75 minutes depending on the load size and dryness required, and select high or low heat depending upon the fabric type. If the sensor does not detect the item the dryer will only operate for 10 minutes before going into cooldown. If the load is too large or too wet to tumble dry the dryer will automatically go into cooldown after approximately 3 hours. PROGRAMME Bone Dry Extra Dry Cupboard Dry Iron Dry Wool Finish A gentle programme specially created to get woollens softer after air-drying. This delicate warm air cycle, lasting 12 minutes, can also be used to get woollens 'refreshed' after being stored in the wardrobe. [. . . ] Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. Gently close the door pushing it slowly until you hear the door 'click' shut. The light next to the push button will light up when the machine is in low heat setting. To deselect in the first few minutes of the programme, press the button, after this time reset the machine to change the setting. [. . . ]