User manual CANDY BMC 60 X

[. . . ] For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 mm between the cook top and the mains. To connect the coffee machine power cord, loosen and remove the cover on the terminal block in order to access the contacts inside. [. . . ] ) with the steam pipe use a suited metallic kettle long and tight with an handle. O In the meantime the appliance is releasing steam it is advisable to move slowly the kettle from up and down in order to mix the liquid while it is heating up. O It is necessary to rotate the steam pipe out of the appliance and perform thae operation described above, paying attention to keep hold the kettle o At the end of steam releasing move the pipe over the drip tray and let it trickle The coffee dispensing can be activated in "MANUAL" or "PROGRAMMED" setting by using the Push-button [B8] as follows: "MANUAL" coffee dispensing setting: If the button [B8] is held down (for less than one second), the machine will dispense coffee. This allows you to memorise a duration for coffee dispensing which could be call back in every moment: o programming duration for coffee dispensing: hold on the push button [B8] for more that 5 seconds. Keeping the button [B8] pressed the appliance will memorise the time for coffee dispensing for as long as the button is held down. When the desired time is reached release the button [B8] and immediately press it twice. Using the coffee dispensing with programmed duration: In order to use the programmed time hold down the button [B8] for more than one second but less than five. After that the button [B8] has been released the machine will dispense coffee for the length of time programmed. : the coffee boiler remains turned on Fill the tank and reselect the function which had previously been activated. Rotate knob [B9] anticlockwise from "+" towards "­" in order to decrease the amount of water which flows out of the coffee boiler. This process is used to make drinks such as tea or tisanes which require a slower flow of water and less of it. The use of coffee pods is an easy, practical and hygienic way to make a coffee. This is due to the special packaging that avoids coffee coming out and it can easily be removed after use. Insert one pod into the filter-holder (Fig A1) and place into the ring nut (Fig A15) making sure that it is correctly secured by turning the filter-holder handle from left to right. Once the dispensing is ended, take the filter-holder out of the ring nut and remove the pod. Switch the coffee machine off and to prevent to burns it is recommended to wait until the appliance get cold. Using a screwdriver unscrew the screw which the water filter for coffee pods to the coffee boiler (- do not lose the old screw) · Hook the adapter (1) to the dispensing unit (3), locking them together with the screw (2). Ensure the coffee machine is kept clean to get the best cup of espresso. The quality and coarseness of the coffee grains can influence the flavour. It is advisable to pay attention on carrying the described operation as the appliance release a steam spout · This coffee machine enables the user to make froth for cappuccinos in two different ways. press the steam dispensing button [B8] to dispense the steam either manually or automatically. When the steam starts coming out, move the container up and down slightly, until the milk makes the froth for the cappuccino. [. . . ] A10) will need changing when you can see white granules in the filter. The coffee machine is equipped with two filter holders (Fig A-1 and A-2). the filter (Fig A-2) is for use with 1-cup filter (Fig A3) or 2-cup filter (Fig A4). The drawer can be used for holding cups and saucers and a compartment for all other accessories such as the filters. [. . . ]