User manual CANDY C 431

[. . . ] The company shall not be liable if the instructions provided in this document are not complied with. The parts of this appliance that may come into contact with foodstuffs comply with the provisions of EEC Directive 89/109. This appliances complies with Directives 89/336/EEC, 73/23/EEC and following changes. If the assistance of the manufacturer is required to rectify faults arising from incorrect installation, this assistance is not covered by the guarantee. [. . . ] Do not use abrasive products, metal cleaning wads, sharp objects, rough cloths, or chemical products and detergents that may permanently damage the catalytic lining. It is a good idea to use deep roasting trays to roast fatty foods such as joints of meat etc. If the walls of the oven are so thickly coated in grease that the catalytic lining is no longer effective remove surplus grease with a soft cloth or sponge soaked in hot water. : All catalytic linings currently on the market have a working life of about 300 hours. If the cause of the fault cannot be detected: disconnect the oven from the mains, do not touch the oven and call the after sales service. Before calling the Service Centre remember to make a note of the serial number on the serial number specifications plate. The oven is supplied with a guarantee certificate that ensures that it will be repaired free of charge by the Service Centre whilst under guarantee. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal. The weight of the food to be cooked or the number of servings/ portions (variable setting, flashing display), can be chosen by turning the central button. The display indicating the weight of the food or the number of servings becomes static. The oven begins cooking in Automatic mode (the Auto sign switch on the display) and the oven starts to heat up. The indicator light flashes until the selected temperature has been reached. An audible signal sounds at the end of this operation and the indicator becomes stable. The cooking time indicator light and the End of cooking time indicator light appear on the display. These settings can be adjusted by turning the programme selector knob to "cooking time" or "end of cooking". the "cooking time" or "end of cooking" display will start flashing. Using the central button, modify the settings as required and then confirm them. When you have finished, do not forget to turn the programme selector knob back to STOP, to confirm a new programme. For more details about programming, refer to the chapter entitled PROGRAMMING. [. . . ] If the blade comes out moist or with bits of cake attached, continue baking but slightly lower the thermostat so that it is finished off without burning. The minutes will then flash, turn the central button to the required number of minutes and confirm by pressing the same button. The hours will flash, turn the central button to the required number of hours and confirm by pressing the same button. An audible signal will sound for 15 seconds and the Timer display will flash (to stop it before the 15 seconds are up, just press the central button). [. . . ]